Abstract:This paper presents a monolithically integrated aptasensor composed of a piezoresistive microcantilever array and an on-chip signal processing circuit. Twelve microcantilevers, each of them embedded with a piezoresistor, form three sensors in a Wheatstone bridge configuration. The on-chip signal processing circuit consists of a multiplexer, a chopper instrumentation amplifier, a low-pass filter, a sigma-delta analog-to-digital converter, and a serial peripheral interface. Both the microcantilever array and the on-chip signal processing circuit were fabricated on the single-crystalline silicon device layer of a silicon-on-insulator (SOI) wafer with partially depleted (PD) CMOS technology followed by three micromachining processes. The integrated microcantilever sensor makes full use of the high gauge factor of single-crystalline silicon to achieve low parasitic, latch-up, and leakage current in the PD-SOI CMOS. A measured deflection sensitivity of 0.98 × 10 − 6 nm −1 and an output voltage fluctuation of less than 1 μV were obtained for the integrated microcantilever. A maximum gain of 134.97 and an input offset current of only 0.623 nA were acquired for the on-chip signal processing circuit. By functionalizing the measurement microcantilevers with a biotin-avidin system method, human IgG, abrin, and staphylococcus enterotoxin B (SEB) were detected at a limit of detection (LOD) of 48 pg/mL. Moreover, multichannel detection of the three integrated microcantilever aptasensors was also verified by detecting SEB. All these experimental results indicate that the design and process of monolithically integrated microcantilevers can meet the requirements of high-sensitivity detection of biomolecules.

Characterizations of microcantilever chemical sensors based on SOI material - art. no. 68360S

Fabrication and characterization of SiO2 microcantilever for microsensor application

Fabrication and Characterization of Sio2 Microcantilever for High Sensitive Moisture Sensor

Simulation and Design of Piezoelectric Microcantilever Chemical Sensors

Fabrication of SiO $_{2}$ Microcantilever Using Isotropic Etching With ICP

Mechanical and Electronic Approaches to Improve the Sensitivity of Microcantilever Sensors.

Chemical Specificity in Nanomechanical Sensors

Micromachined SiO 2 microcantilever for high sensitive moisture sensor

Simulation of SiO2-based Piezoresistive Microcantilevers

Thin Layer Soi-Fets Used for Stress-Sensing and Its Application in Accelerometers

A Monolithically Integrated Microcantilever Biosensor Based on Partially Depleted SOI CMOS Technology

A Front-Side Released Single Crystalline Silicon Piezoresistive Microcantilever Sensor

Design of High-Sensitivity Cantilever and Its Monolithic Integration with CMOS Circuits

A Silicon Microcantilever Biosensor Fabricated on SOI Wafers Using a Two-Step Releasing Approach

Design, Fabrication And Characterization Of A Two-Step Released Silicon Dioxide Piezoresistive Microcantilever Immunosensor

Design of Piezoresistive Micro-Cantilever with Stress Concentration Regions

Chemical and Biological Sensors Based on Microcantilever Structure

A Reflective Mirror Microcantilevers-Based Biosensor for Biochemical Detection

Cantilever-based Transducer for Molecules Configuration Research

Design and Optimization of SOI Piezoresistive Microcantilever Sensors for Use in Surface Stress Measurement

Characterization and Analysis of a Novel Structural SOI Piezoresistive Pressure Sensor with High Sensitivity and Linearity