Abstract:Tantalum silicate (Ta–Si–O) thin film materials have gained significant interest in hybrid renewable energy systems and thin-film resistors due to their exceptional thermal stability and adjustable electrical properties. In this study, we investigated the effects of target compositions and sputtering power densities on the material structures, chemical compositions, microstructures, and electrical properties of Ta–Si–O films. Two target compositions, Ta 65 (SiO 2 ) 35 and Ta 80 (SiO 2 ) 20 , were utilized in the deposition process. Notably, we observed substantial variations in the temperature coefficient of resistance (TCR) value and resistivity of Ta–Si–O thin films with different Ta concentrations. Most importantly, when the Ta content of the film is controlled at 62 ± 0.6 % by using this target, the resistivity of the Ta 0.62 Si 0.20 O 0.18 film can be as small as 2.31 ± 0.05 × 10 −4 Ω-cm and has an extremely small TCR of 22 ± 0.4 ppm/°C, which shows an excellent opportunity for the development of precision thin film resistors. A TCR value close to zero can be finely tuned by controlling the Ta concentration in the Ta–Si–O film. These intriguing electrical behaviors were found to be highly correlated with the predominant formation of metallic Ta 5 Si 3 as the main structural phase in the films. This work presents a simple and effective approach to produce Ta–Si–O thin films with near-zero TCR, making them highly suitable for applications under high-temperature conditions. Our findings contribute to the development of tailored thin film materials with desirable electrical properties for advanced electronic and energy devices.

Study on matching resistor of 40Gb/S high-speed submounts

On-chip High Precision Terminating Resistors for High Speed Transmitter

Design, Fabrication And Measurement Of Tan Thin Film Resistor Based On Mems Technology

On-chip high precision terminating resistors for transmitter

Experimental Characterisation and Modelling of On-Chip Capacitors and Resistors on GaAs Substrates

Process Development of A New Tgv Interposer for Wafer Level Package of Inertial Mems Device

Implementation Of Temperature Dependent Contact Resistance Model For The Analysis Of Deep Submicron Devices Under Esd

Development and Characterization of TaN Thin Film Resistor with CMOS Compatible Fabrication Process.

Bing Xiong, Jianbo Tian, Jian Wang, Pengfei Cai, Changzheng Sun

Novel Low-Cost Wideband Si-Based Submount for 40 Gb/S Optoelectronic Devices

HIGH-SPEED Al2O3 -BASED SUBMOUNT FOR 40Gb/s ELECTROABSORPTION MODULATORS

High-Speed Coplanar Waveguide Based Submount for 40 Gbit/s Electroabsorption Modulator

Temperature Dependence of the Specific Resistance in Ti/Al/Ni/Au Ohmic Contacts on (nh4)2sx Treated N-Type GaN

Design and Fabrication of DC-18GHz Microwave Power Thin Film Resistors

Temperature Dependent Characteristics of Ti/Al/Ni/Au Ohmic Contact on Lattice-Matched In0.17Al0.83N/GaN Heterostructures

Design Of Single Thin Film Resistor Network As 20db Attenuator For Dc-20ghz Application

Low-Resistance Ta/Al/Ni/Au Ohmic Contact and Formation Mechanism on AlN/GaN HEMT

Very low resistance Au/Ge/Ni/Ag based Ohmic contact formation to Al0.25/Ga0.75As/GaAs and Al0.48In0.52As/Ga0.47In0.53As heterostructures: A behavioral comparison

Influence of room-temperature oxidation on stability and performance of reactively sputtered TaN thin films for high-precision sheet resistors

Fabrication of tantalum silicate films with low TCR and low resistivity by magnetron sputtering

Design and fabrication of heat sink with impedance matching circuit for high-speed EA modulators