Abstract:Ultrasonic wedge bonding of aluminum (Al) wires is a widely applied interconnect technology for power elec-tronic packaging. The joint quality of the wedge bonding is mainly affected by the process parameters and material properties. Inappropriate process parameters will lead to failure modes such as chip surface pit, metal layer peeling off, wire cracking, non-sticking to the pad, etc., which limits the long-term stability of power devices. In order to reach the desired reliability, the design of experiment (DoE) is generally deployed which is costly in terms of time and related materials. Therefore, simulation-assisted analysis is in demand to rapidly narrow down the process windows. In this paper, an ultrasonic bonding model involving thick Al wires (300 mu m) was established based on the Finite Element Method (FEM), to optimize process parameters effectively with reduced time and cost. The model was designed in ANSYS utilizing the transient structural mechanics module with various stresses and ultrasonic power, to simulate the relative deformation of the bonded wires and the displacement against the substrate. The result was then verified by ultrasonic wedge bonding samples with 9 sets of process parameters. The stress distributions were simulated and analyzed with the failure modes of tensile strength tests, while the deformation of wires under various process parameters was measured and compared with shear strength tests. Further, the relationship between the failure modes of the joint and the deformation was then analyzed by Response Surface Method (RSM), and the regression equation of the wire deformation and related process parameters was established and fitted with the actual sample's data. Such analysis not only found the optimum range of the deformation of thick Al ultrasonic wire bonds but also quickly provided a range of optimized processes for Al thick wires applying ultrasonic wedge bonding techniques.

Model Investigation on Characteristic of Anodic Bonding Current

Electric Current Characteristic of Anodic Bonding

Investigation of electrostatic bonding time model with point cathode

Process Simulation Based on Anodic Bonding Models

Current Formulas of Silicon-Glass Anodic Bonding

Parameter Characterization of Anodic Bonded Electrical Interconnect in MEMS/NEMS Devices

Theoretical Derivation of the Effect of Bonding Current on the Bonding Interface during Anodic Bonding of PEG-Based Encapsulation Materials and Aluminum

Investigation of the Contact Characteristics of Silicon–Gold in an Anodic Bonding Structure

A Novel Application Of Anodic Bonding For Electrical Interconnect And Its Parameter Characterization

Experimental Research of the Anodic Bonding in the Si-Glass-Si 3-Layer Structure

Study on the Conductivity Model of SCC by Using a New Eddy Current Probe

Simulation of aluminium electrodeposition on complex geometry: Influence of input parameters and electrodeposition conditions

Modeling of Anodic Bonding with SiO2 Dielectric As Interlayer

A model investigation of the performance of a novel anode flow-field structure with microblocks for micro direct methanol fuel cells

A Closed-Loop Constant Deposition Current Control Method Based on MCED Circuit Model

Experimental and multiphysics simulation study of atoms migration and morphology evolution in solder joints under high current density

A Study of Advanced Modeling Methodology of CMOS-compatible RF-MEMS Devices for Integrated Circuit Design

A New Test Structure To Measure Bonding Strength In Micro-Bonding Area

Finite element modeling and analysis of ultrasonic bonding process of thick aluminum wires for power electronic packaging

Anodizing model and CV simulation for etched aluminium foil for high voltage