Abstract:In metal matrix composites, the existence of the interface phase imparts a complex influence on the interface bonding of the composites, while robust interfacial bonding is imperative for efficacious load transfer, which plays a crucial role in improving the mechanical properties of the composites. The purpose of this study is to investigate the effect of interface BeO content on the interfacial bonding strength and mechanical properties of Be/Al composites. Two types of Be/Al composites were prepared by self-exhausting pressure infiltration method, one of which was preheated in air atmosphere and the other was preheated under argon protection. Microstructural analysis results showed that significant oxidative corrosion occurred on the surface of beryllium particles in the Be/Al composite preheated in air atmosphere, and a considerable amount of oxide existed at the Be/Al interface, forming an oxide layer with oxide beryllium nanoparticles with particle sizes of 20 50 nm. The interface of the Be/Al composite preheated under inert atmosphere was the direct combination of beryllium phase and the aluminum phase, with a few localized areas containing a small amount of aluminum oxide. Furthermore, mechanical property tests showed that the Be/Al composite preheated under inert atmosphere exhibited better mechanical properties and higher interfacial bonding strength. The first-principle simulation results further confirmed that the low interfacial bonding strength of the Be/Al composite preheated in air atmosphere was due to the much lower adhesion work of the BeO/Al interface than that of the Be/Al interface, and no bonding trend was observed between BeO and Al. The results of this study indicate that the presence of an abundance of interfacial BeO can lead to the deterioration of the Be/Al interface bonding, and avoiding the production of interfacial BeO is crucial in obtaining better interfacial bonding. These findings point out the direction for the design and preparation of high-performance Be/Al composites.

Theoretical Derivation of the Effect of Bonding Current on the Bonding Interface during Anodic Bonding of PEG-Based Encapsulation Materials and Aluminum

Electric Current Characteristic of Anodic Bonding

Al-clad Cu Bond Wires for Power Electronics Packaging: Microstructure Evolution, Mechanical Performance, and Molecular Dynamics Simulation of Diffusion Behaviors

Ppc-Based Bilayer Temporary Bonding and Debonding

Interface Microstructure of Aluminum Die-Casting Alloy Joints Bonded by Pulse Electric-Current Bonding Process

Effect of electric current on stability of solidification interface morphology

Model Investigation on Characteristic of Anodic Bonding Current

Viscous Layer Formed in the Anodic Electrolytic Etching of Reactive Metals in Ionic Liquid

Influences of surface oxide films of aluminum bondpads on gold wire bonding

Investigation of electrostatic bonding time model with point cathode

Modeling of Anodic Bonding with SiO2 Dielectric As Interlayer

Flexible anodic bonding for the bonding between elastomer and metal

Electrochemical Characterization of Electrically Induced Adhesive Debonding

Effect of Interfacial BeO Content on Microstructure and Mechanical Properties of Beryllium/aluminum Composites

Process Simulation Based on Anodic Bonding Models

Current Formulas of Silicon-Glass Anodic Bonding

Effects of interfacial bonding strength on the formation of conductive anodic filament in polyphenylene oxide/glass fiber laminates

Parameter Characterization of Anodic Bonded Electrical Interconnect in MEMS/NEMS Devices

Effects of Pd Alloying and Coating on the Galvanic Corrosion between Cu Wire and Bond Pads for a Semiconductor Packaging

Anode current effects in plasma electrolytic oxidation

Study on the Anodic Bonding Mechanism of Polymer Electrolyte and Aluminum Based on MEMS Sensor Package