Abstract:Flux-switching permanent magnet (FSPM) machines are gaining in popularity due to their robustness, wide speed range, high torque, and high power density. However, their cogging torque leads to vibration and noise due to the double-saliency structure. This paper investigates the effects of the short permanent magnet (PM) and stator flux bridge (FB) on the cogging torque reduction of three-phase 12-/10-pole FSPM machines. Four different FSPM machines, including the inner-inner topology, inner-outer topology, outer-inner topology, and outer-outer topology, are developed and analyzed with both short PM and stator FB. The configurations are obtained by placing the FB at inner/outer stator lamination and reducing the PM toward inner/outer axial directions. The cogging torque, average output torque, and PM utilization ratio of different topologies are extensively studied and compared by the finit-eelement method. Finally, prototype machines are manufactured and tested. The experimental results have validated the numerical models and the effectiveness of the developed machine in reducing the cogging torque. The results also suggest that the outer-inner topology is more effective to reduce the cogging torque, which not only reduces the utilization of the PM materials, but also mitigates the cogging torque at only slight cost of machine performance.

Study of magnet shifting for reduction of cogging torque in permanent magnet motors

A Cogging Torque Reduction Method for Surface Mounted Permanent Magnet Motor

Investigation of Short Permanent Magnet and Stator Flux Bridge Effects on Cogging Torque Mitigation in FSPM Machines

Reduction Methods Using Canceling Effect for Cogging Torque in Dual-Stator PM Synchronous Machines

Reduction of Cogging Torque in Permanent Magnet Synchronous Motor Using the Taguchi Method

Influence of Pole and Slot Number Combinations on Cogging Torque in Permanent-Magnet Machines with Static and Rotating Eccentricities

Influence of Stator Asymmetry on Cogging Torque of Permanent Magnet Brushless Machines

Superposition Method for Cogging Torque Prediction in Permanent Magnet Machines with Rotor Eccentricity

Solution of Permanent Magnet Synchronous Motors with Partition between Poles Halbach Magnet

Analysis and Reduction of Detent Force in Permanent Magnet Linear Synchronous Motor

Analysis and Reduction of Inherent Shaft Voltage in Interior Permanent Magnet Synchronous Machines

Optimization of the Different Pole Arc Combination to Reduce the Cogging Torque in PMDC Motors

Method for Reducing Cogging Torque Based on Magnet Skewing in Disc-Type Permanent Magnet Motors

A Study on Cogging Torque Reducing Method of BLDC Motors

Reduction of Cogging Torque in Permanent Magnet Flux-Switching Machines

Cogging Torque Reduction of Permanent Magnet Motor Based on Particle Swarm Optimization Algorithm

Reduction of cogging torque of radial flux permanent magnet brushless DC motor by magnet shifting technique

Research on cogging torque characteristics of permanent magnet synchronous machines with the same number of poles and slots

Cogging Torque Reduction in Permanent Magnet Flux-Switching Machines by Rotor Teeth Axial Pairing

Detent-Force Analysis and Reduction of Modular Permanent-Magnet Linear Synchronous Motors with Non-overlapping Windings

Analytical Analysis of Cogging Torque in Permanent Magnet Machines With Unequal North and South Poles, with Particular Reference to Consequent Pole Machines