Abstract:Flux-switching permanent magnet (FSPM) machines are gaining in popularity due to their robustness, wide speed range, high torque, and high power density. However, their cogging torque leads to vibration and noise due to the double-saliency structure. This paper investigates the effects of the short permanent magnet (PM) and stator flux bridge (FB) on the cogging torque reduction of three-phase 12-/10-pole FSPM machines. Four different FSPM machines, including the inner-inner topology, inner-outer topology, outer-inner topology, and outer-outer topology, are developed and analyzed with both short PM and stator FB. The configurations are obtained by placing the FB at inner/outer stator lamination and reducing the PM toward inner/outer axial directions. The cogging torque, average output torque, and PM utilization ratio of different topologies are extensively studied and compared by the finit-eelement method. Finally, prototype machines are manufactured and tested. The experimental results have validated the numerical models and the effectiveness of the developed machine in reducing the cogging torque. The results also suggest that the outer-inner topology is more effective to reduce the cogging torque, which not only reduces the utilization of the PM materials, but also mitigates the cogging torque at only slight cost of machine performance.

Reduction of Cogging Torque in Permanent Magnet Flux-Switching Machines

Investigation of Short Permanent Magnet and Stator Flux Bridge Effects on Cogging Torque Mitigation in FSPM Machines

A Cogging Torque Reduction Method for Surface Mounted Permanent Magnet Motor

Influence of Design Parameters on Output Torque of Novel Doubly-Fed Flux-Switching Permanent Magnet Machines

Novel Modular-Rotor Switched-Flux Permanent Magnet Machines

Optimization and Comparison of Dual-Armature Flux-Switching Permanent Magnet Machines with Different Stator Core Shapes

Influence of Stator and Rotor Pole Number Combinations and Winding Configurations on Flux-Weakening Performance of Switched-Flux PM Machines

Reduction of Cogging Torque in Permanent Magnet Synchronous Motor Using the Taguchi Method

Reduction Methods Using Canceling Effect for Cogging Torque in Dual-Stator PM Synchronous Machines

Cogging Torque Reduction in Permanent Magnet Flux-Switching Machines by Rotor Teeth Axial Pairing

Study of magnet shifting for reduction of cogging torque in permanent magnet motors

Permanent magnet flux switching machines — Topologies, analysis and optimization

Some Optimal Design Methods for Permanent Magnet Flux Switching Linear Machines

Torque Analysis of Permanent-Magnet Flux Switching Machines with Rotor Step Skewing

Cogging Torque Suppression in A Permanent-Magnet Flux-Switching Integrated-Starter-Generator

Flux Weakening Control Of Interior Permanent Magnet Synchronous Machine To Improve Torque Performance

Comparative Analysis of Doubly Fed Flux-Reversal Permanent Magnet Machines with Different PM Arrangements and Consequent-Pole Topologies

Investigation of Torque Characteristics in a Novel Permanent Magnet Flux Switching Machine with an Outer-Rotor Configuration

A Novel Doubly-Fed Flux-Switching Permanent Magnet Machine with Armature Windings Wound on Both Stator Poles and Rotor Teeth

Design and Analysis of a Novel Dual-PM Flux Reversal Machine for Electric Vehicle Propulsion

A New Method for Reduction of Detent Force in Permanent Magnet Flux-Switching Linear Motors