CALCULATION OF HYDRO-FORMING PRESSURE FOR BI-METAL CLAD PIPE
王学生,李培宁,王如竹,许煜雄
DOI: https://doi.org/10.3321/j.issn:1001-9669.2002.03.034
2002-01-01
Abstract:The double-wall, bimetallic CRA-lined pipe has an inner layer made of a very resistant CRA and an outer layer made of low-cost carbon steel providing the line pipe with the required strength and toughness, which has been widely applied in oil production, nuclear power plants and refining industry. Clad pipe can be manufactured by various techniques that include hot coextrusion, hot-rolled bonding, explosive bonding, centrifugal casting and hydraulic expansion of a CRA pipe inside and a carbon-steel outer pipe. Compared with kinds of methods, hydraulic expansion process is easy to control, clad pipe can be economically manufactured and its quality is better, so it is deserved to develop. This paper mainly presents the clad pipe, which inner pipe is stainless steel and outer pipe is carbon steel to be formed by hydraulic expansion process. According to the basic supposition,the material and mechanics models of inner pipe and outer pipe have been established. (1) The material of the inner piper is considered as linear hardening behavior, and the outer pipe is described as ideally plastic material since its plastic deformation is smaller. (2) During the hydraulic expansion, the axial force in pipes can be neglected according to our experimental model, so the stress on pipes can be got by simplified as problem of planar stress. The main principle of hydraulic expansion process for clad pipe has been described. Adopting the elasticity-plasticity theory, the stress and strain during loading and the residual stress and strain after unloading for the inner and outer pipe of clad pipe have been discussed. By using the distortion matching condition the calculating formulas related hydro-forming pressure to the residual contact pressure between has been derived. The range of expansion pressure is got according to the different demands for residual contact pressure of clad pipe, and the maximum and minimum value of hydro-forming pressure is given. In order to obtain the residual contact pressure, the yield stress of outer pipe must be more than inner pipe or it's hardening stress. The theoretical analysis is verified by experimental results.