Abstract:Initial geometric imperfections and corrosion defects were considered as two of the most common imperfections for subsea pipes, which could lead to an inevitable reduction of collapse capacity. In this study, the coupling effect of both types of defects on the collapse performance was investigated numerically, with a particular focus on the relative corrosion position as described by defect location angle (DLA). A customised numerical framework was established to efficiently build FE models with various corrosion defects and imperfect geometry. Verification of the finite element (FE) model was performed using existing experiments in the open literature. In addition, extensive sensitivity studies were then conducted for several key problem parameters, including defect length, width, depth, initial ovality, and DLA. The variation of normalised collapse pressure with DLA exhibits two types of trajectories, namely 'Minor Decrease' and 'Constant-Decrease-Constant' responses. In the first, the normalised collapse pressure decreases slightly with increasing DLA. Among these cases, if the ratio stays above or close to 1.0, the collapse takes the form of classical ovalization mode. In contrast, for cases below 1.0, the collapse occurs in the corroded region. For the latter type of trajectory, the normalised collapse pressure follows a 'Constant-Decrease-Constant' path, and the collapse mode involves ovalization, anti-ovalization, non-symmetrical and U-shaped pattern. Subsequently, a series of empirical formulas were proposed upon extensive simulation results to predict the collapse pressure of non-symmetrical defect pipes.

Parametric study for confined collapse of unbonded multi-layer pipe

Confined Collapse of Unbonded Multi-Layer Pipe Subjected to External Pressure

Numerical Study of CFRP-Bonded Pressure Pipes Subject to Impact Load

Plastic Collapse Analysis of Thin-Walled Pipes Based on Unified Yield Criterion

Strength Differential Effect and Influence of Strength Criterion on Burst Pressure of Thin-Walled Pipelines

An analytical approach for assessing the collapse strength of an unbonded flexible pipe

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

On the Influence of Interacting Dual Defects on the Collapse Pressure of Pipes under External Pressure

On the Collapse Failure of Dented Pipes under Bending Moment and External Pressure

Limit bending moment for pipes with two circumferential flaws under combined internal pressure and bending

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

On the collapse of thick-walled steel pipes under coupling initial geometric imperfection and corrosion defect

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

On Elastic-Plastic Collapse of Subsea Pipelines under External Hydrostatic Pressure and Denting Force

Local buckling of deepwater oil-gas pipeline under high hydrostatic pressure

Buckling Response of Offshore Pipelines under Combined Tension, Bending, and External Pressure

Surface Stress Analysis of Internally Corroded Pipes under External Pressure

Safety analysis of pressure piping containing incomplete penetration under combined loads

On the Collapse of Thick-Walled Pipes with Corrosion Defects under External Pressure