Abstract:Recent electronic industry developments require a variety of compact and high-performance heat sinks for the heat dissipation of electronic devices. In this paper, on the basis of a new type of heat pipe called the metal foam multichannel heat pipe (metal foam MCHP) proposed by our team, an experimental apparatus on its heat transfer characteristics was built. The heat transfer characteristics of the metal foam MCHP with the distilled water as the working fluid were experimentally investigated in a heat flux range of (18750-112500) W/m(2), a filling ratio range of 0.1-0.6 and single-sided/double-sided heating modes. The experimental results showed that the working fluid could flow up and down in the metal foam MCHP, and thus the heat was transferred from the evaporation section to the condensation section during the operation. The thermal resistance of the metal foam MCHP decreased with the increase of the heat flux. When the heat flux was up to 112500 W/m(2), the thermal resistance decreased to 0.142 degrees C/W. The optimal filling ratio of the metal foam MCHP charging with the distilled water was 0.2. During the experiment, the temperature fluctuations of each measuring point in the evaporation section were almost within 2 degrees C and the temperature differences of different measuring points in the evaporation section were within 8 degrees C. The thermal resistances of the metal foam MCHP under the single-side heating mode and the double-sided heating mode were compared, and the thermal resistance of the metal foam MCHP was found to be higher under the single-sided heating mode. In addition, compared with the traditional PHPs, the metal foam MCHP showed better heat transfer performance and better stability and uniformity of the evaporation temperature. (C) 2020 Elsevier Ltd. All rights reserved.

Experimental investigation on heat transfer performance of closed-loop pulsating heat pipe with large inner diameter

Experimental Research on Heat Transfer Performance of 3 mm Closed Pulsating Heat Pipe

Experimental Research on the Start-Up Characteristics and Heat Transfer Performance of Pulsating Heat Pipes with Rectangular Channels

Investigation on the Influence of Different Heat Transmission Distances on Thermo-Hydrodynamic Characteristics of Pulsating Heat Pipes

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Experimental Study on a Hydrogen Closed-Loop Pulsating Heat Pipe with Two Turns

Transient Numerical Model on the Design Optimization of the Adiabatic Section Length for the Pulsating Heat Pipe

Review of the Development of Pulsating Heat Pipe for Heat Dissipation

Experimental Study on a Hydrogen Closed Loop Pulsating Heat Pipe with Different Adiabatic Lengths

Experimental Study on the Thermo-Hydrodynamic Characteristics of a Nitrogen Pulsating Heat Pipe

Partial Visualization Study on Flow, Startup and Heat Transfer Characteristics of Closed-Loop Pulsating Heat Pipe with R1336mzz(Z)

Experimental Investigation of the Influence of Surfactant on the Heat Transfer Performance of Pulsating Heat Pipe

Experimental Study on a Hydrogen Pulsating Heat Pipe in Different Heating Modes

Theoretical and Experimental Research on Heat Transfer Performance of the Semi-Open Heat Pipe

Numerical Investigation on Pulsating Heat Pipes with Nitrogen or Hydrogen

Numerical investigation on the start-up and heat transfer performance of dual-diameter pulsating heat pipes

Performance of a Vertical Closed Pulsating Heat Pipe with Hydroxylated MWNTs Nanofluid

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Experimental Study on Hydrogen Pulsating Heat Pipes under Different Number of Turns

Numerical Study of the Thermal Performance of a Hydrogen Pulsating Heat Pipe

Single-Loop Triple-Diameter Pulsating Heat Pipes at Reduced Heat Input: A CFD Study on Inner Diameter Optimization