Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

Design of Clock and Data Recovery Circuit For RFID Tag

A Digital Intensive Clock Recovery Circuit for HF-Band Active RFID Tag

A Clock and Data Recovery Circuit for Non-Return-Zero Data

New Design of Clock Self Recovery Circuit Based on Time-to-voltage Conversion

10 Gb/s Linear Full-Rate CMOS Phase Detector for Clock Data Recovery Circuit

Non-Sequential Linear Cmos Phase Detector for Cdr Applications

A Digital Baseband with Novel Clock Generator for UHF RFID Tag

Clock Data Recovery Based on Delay Chain for Medium Data Rate Transmission

High Data Capacity Chipless RFID Tag Based on Time Domain Scattering Modulation

A High Performance Power Recovery Circuit for UHF RFID Tags

Clock Regenerator and Backscatter Modulator for UHF RFID Application

A Novel Clock and Data Recovery Technique Based on Sigma-Delta Phase Quantization

A low-power 10Gb/s CMOS clock and data recovery circuit with a quarter-rate phase detector

A 0.7-pJ/b 12.5-Gb/s Reference-Less Subsampling Clock and Data Recovery Circuit

New-type Adaptive Decoding Circuit for Passive UHF RFID Tag

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

A Power Scalable 2-10 Gb/s PI-based Clock Data Recovery for Multilane Applications.

A 800nw High-Accuracy Rc Oscillator with Resistor Calibration for Rfid

A Low-Power Dual-Clock Strategy for Digital Circuits of Epc Gen2 Rfid Tag

A Low Noise Fault Tolerant Radiation Hardened 2.56 Gbps Clock-Data Recovery Circuit With High Speed Feed Forward Correction in 65 nm CMOS

A Novel Clock And Data Recovery Scheme Based On Sigma-Delta Quantization