Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

A Clock and Data Recovery Circuit for Non-Return-Zero Data

Non-Sequential Linear Cmos Phase Detector for Cdr Applications

Design of Clock and Data Recovery Circuit For RFID Tag

10 Gb/s Linear Full-Rate CMOS Phase Detector for Clock Data Recovery Circuit

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector

New Design of Clock Self Recovery Circuit Based on Time-to-voltage Conversion

A Novel Clock And Data Recovery Scheme Based On Sigma-Delta Quantization

A Novel Clock and Data Recovery Technique Based on Sigma-Delta Phase Quantization

Performance Analysis of a Novel Chip Tracking Loop Used for Regenerative Pseudo-Noise Ranging Clock Recovery

A 5/10 Gb/s Dual-Mode NRZ/PAM4 CDR in 65-Nm CMOS

Design and Implementation of a Rapid Synchronous Clock and Data Recovery Circuit

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

A Low Noise Fault Tolerant Radiation Hardened 2.56 Gbps Clock-Data Recovery Circuit With High Speed Feed Forward Correction in 65 nm CMOS

A 6.25Gb/s CMOS clock and data recovery DLL with anti-harmonic lock

A 3.125gbit/s CMOS Clock and Data Recovery Circuit

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A 1/4-RATE LINEAR PHASE DETECTOR FOR HIGH SPEED PLL-BASED CLOCK AND DATA RECOVERY CIRCUIT

A 1.25-8.5 Gb/s Wide Range CDR with Locking Detector in 40 Nm CMOS Technology

Delay‐locked Loop Based Clock and Data Recovery with Wide Operating Range and Low Jitter in a 65‐nm CMOS Process

A 10gbps Half-Rate Digital Clock and Data Recovery Circuit for 60ghz Receiver in 65nm CMOS

Clock Data Recovery Based on Delay Chain for Medium Data Rate Transmission