Abstract:The modeling of the asymmetric cold rolling process of steel strip is carried out using the Deform program. During the study, the diameter of the barrel of the upper work roll is varied from 570 to 600 mm, the diameter of the barrel of the lower work roll was left unchanged at 600 mm, and changes in the structural parameters of the deformation zone, as well as the required rolling torques and forces, are recorded. The results are obtained for the conditions of rolling strips made of low-carbon steels with a thickness of 2 mm or more, as well as 0.35...0.5 mm. It is found that the discrepancy in power between the drives of the upper and lower rolls during asymmetric rolling can reach 25 % of the power required to conduct the process on rolls with the same barrel diameter. It is also shown that the changing of the contact arc with the indicated changes in power and a decrease in the diameter of the working roll barrel from 600 to 570 mm ranges from 3 to 5 % of the length of the arc of contact in the absence of a difference in the diameters of the barrels of the rolls. Fluctuation in moments when taking into account the factor of asymmetric rolling reaches 20 % of the corresponding values typical for the technological process on rolls with the same barrel diameter. An increase in the asymmetry of the rolling process leads to a slope of the neutral section in the deformation zone with an increase in the proportion of the advance zone in the arc of contact of the upper work roll with a smaller diameter of the barrel and the strip. An assumption is made, which requires further research, about the possibility of creating only one advance section along the entire length of the interaction of the roll with a smaller diameter of the barrel and the strip. Such a structure of the contact zone is theoretically able to reduce the required power of the main drive.

Orthogonal Test and Analysis of Warping Phenomenon in Plate Rolling Process

The Causes and Control of Longitudinal Edge Cracks of the Plate

Experimental Analysis of Warping Defects in Chain-die Forming Variable-width Profiles

Research on the Mechanism and Processability of Roll Forming

Development and Application on Simulation System of Plate Rolling

Modeling for warping prediction and control in cold rotary forging of round plate

The central strain analytical modeling and analysis for the plate rolling process

Research and application of the angular rolling technology for plate mill

Research onForecast of Roll Wear of PC Mill

Theoretical Study of Asymmetric Bending Force on Metal Deformation in Cold Rolling

Modeling and analysis of deformation characteristics for the two-layered metal clad plate produced by asymmetric rolling

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

Prevention and Analysis of Producing Bendiogs on Ends of Aluminium Plate during Hot Rolling

An analytical model of plate rolling force with a simple available velocity field and equal perimeter yield criterion

Finite Element Analysis of Temper Rolling Process

Nonlinear Vibration Characteristic Analysis of Roller-Plate System Based on Asymptotic Methods

Analytic Numerical Modeling for Thermal Mechanical Processing of Plate under Rolling

A 2.5-Dimensional Analytical Model of Cold Leveling for Plates with Transverse Wave Defects

Numerical simulation of cold longitudinal asymmetric rolling process

Analytical and Finite Element Analysis of the Rolling Force for the Three-Roller Cylindrical Bending Process

Rolling Process Analysis of Working Rollers of Cold Rolling Mill Based on ANSYS