Abstract:Post deposition annealing of molecular layer-deposited (MLD) hafnicone films was examined and compared to that of hafnium oxide atomic layer-deposited (ALD) films. Hafnicone films were deposited using tetrakis(dimethylamido)hafnium (TDMAH), and ethylene glycol and hafnia films were deposited using TDMAH and water at 120 °C. The changes in the properties of the as-deposited hafnicone films with annealing were probed by various techniques and then compared to the as-deposited and annealed ALD hafnia films. In situ X-ray reflectivity indicated a 70% decrease in thickness and ∼100% increase in density upon heating to 400 °C yet the density remained lower than that of hafnia control samples. The largest decreases in thickness of the hafnicone films were observed from 150 to 350 °C. In situ X-ray diffraction indicated an increase in the temperature required for crystallization in the hafnicone films (600 °C) relative to the hafnia films (350 °C). The changes in chemistry of the hafnicone films annealed with and without UV exposure were probed using Fourier transformed infrared spectroscopy and X-ray photoelectron spectroscopy with no significant differences attributed to the UV exposure. The hafnicone films exhibited lower dielectric constants than hafnia control samples over the entire temperature range examined. The CF4/O2 etch rate of the hafnicone films was comparable to the etch rate of hafnia films after annealing at 350 °C. The thermal conductivity of the hafnicone films initially decreased with thermal processing (up to 250 °C) and then increased (350 °C), likely due to porosity generation and subsequent densification, respectively. This work demonstrates that annealing MLD films is a promising strategy for generating thin films with a low density and relative permittivity.

A New Hcp Phase Formed in the Ni-Nb System During Ion-beam-assisted Deposition

Amorphization in the Ni–Nb System Upon Ion-Beam-Assisted Deposition

Structural phase transition in the Hf–Ni system studied by ab initio calculation and ion beam mixing

Metastable phases formation in Cu–Nb films by ion-beam-assisted deposition

Amorphization and Phase Evolution in Fe–Nb Films Prepared by Ion Beam Assisted Deposition

Possible new metastable state observed in the Ni-Nb system by ion irradiation

Microstructures of Nb–Ti Alloy Films Prepared by Ion Beam Assisted Deposition

Amorphization in Nb-M (M=Fe, Co, Ni) binary metal systems induced by ion beam assisted deposition (IBAD)

Amorphous Phase and Anisotropy Induced by Glancing Incident Ion Beams in Co–Nb Films

Solid State Phase Transition Induced by Ion Irradiation in the Co-Nb System: Experiments and Thermodynamics

Irradiation‐Induced Extremes Create Hierarchical Face‐/Body‐Centered‐Cubic Phases in Nanostructured High Entropy Alloys

Ion Beam Induced Growth of Amorphous Alloy Films in the Co–Nb System During Ion Beam Assisted Deposition

Amorphization In The Immiscible Cu/Ta And Cu/Nb Multilayers By Ion Beam Assisted Deposition

Formation of A Hexagonal-Close-Packed Phase in Ni3r (R = Mo, Nb, Ta) Multilayered Films by Solid-State Reaction

Non-equilibrium Alloy Phase Formation and Transformation Driven by Ion Beam Mixing in the Fe-Hf-Nb Multilayers

Phase Evolution Upon Ion Mixing and Solid-State Reaction and Thermodynamic Interpretation in the Ni-Nb System

Chemical, Structural, and Electrical Changes in Molecular Layer-Deposited Hafnicone Thin Films after Thermal Processing

Formation of Metastable Alloy Films in the Ni-Mo Binary System by Ion-Beam-assisted Deposition

Amorphization and Nano-Crystallization of Ni-Nb Coating on GH3039 Alloys by High Current Pulsed Electron Beam

Metastable Phases Formed by Ion Mixing in the Hf-Nb System with A Positive Heat of Formation

Amorphous Phase Formation, Spinodal Decomposition, and Fractal Growth of Nanocrystals in an Immiscible Hf–Nb System Studied by Ion Beam Mixing and Atomistic Modeling