Abstract:This paper attempts to present a brief review of recent progress obtained by the author's group in the research area of ion beam metallurgy, namely (i) formation of metal-nitride by nitrogen implantation; (ii) metallic glass formation by ion mixing; and (iii) icosahedral phase formation by ion mixing. Silver- and copper-trinitrides have been formed, for the first time, by RT 80 keV nitrogen ion implantation for doses up to 2×10 18 N cm −2 . These indicated that deposition of large amounts of energy during implantation could provide the reaction energy of noble-metal-nitride with rather positive heat of formation, and that local nitrogen concentration in the implanted films could be considerably greater than that limited by the sputtering yield involved. Besides, our observation of the reverse sequence of phase transition TiTiNTi 2 N with increasing nitrogen dose suggested that growth kinetics (or structural compatibility between newly formed phase and the matrix) might be a key factor in determining the nitride formation in some systems. Two parameters were found of importance in influencing the glass forming ability (GFA) of binary metal systems. One is MPAR (maximum possible amorphization range), which equals 100% minus the maximum solid solubilities observed in the equilibrium phase diagram. The other is the heat of formation. A map was constructed by these parameters and some empirical qualifications were found to classify the systems according to GFA into three categories of Hardly (HGF), Possible (PGF) and Readily (RGF) Glass Forming systems. The FeCu system is an immiscible one, in which amorphization induced by ion mixing could only occur within a narrow composition range. The favored composition was figured out experimentally, and an icosahedral phase was also formed by ion mixing without post-annealing at corresponding atomic stoichiometry. Interestingly, a similar phase was also formed in the FeMo system.

Non-equilibrium Alloy Phase Formation and Transformation Driven by Ion Beam Mixing in the Fe-Hf-Nb Multilayers

Irradiation induced non-equilibrium phase formation and structural transformation in the Fe–Ti–Nb multilayered films

Synthesis of Amorphous Alloys and Amorphous-Crystalline Composites in the Cu-Nb-Hf System by Ion Beam Mixing

Ion Mixing to Synthesize Amorphous and Metastable Crystalline Alloys in the Fe-Ta System

Structural phase transition in the Fe–Ta system studied by ion beam mixing

Metastable alloys synthesized by ion mixing in immiscible Ti–Nb and Ti–Ta systems

Formation of Non Equilibrium Solid Phases in Fe-Nb Multilayered Films by Ion Irradiation

Metastable Phase Formation and Magnetic Properties of the Fe–Nb System Studied by Atomistic Modeling and Ion Beam Mixing

Phase Evolution Upon Ion Mixing and Solid-State Reaction and Thermodynamic Interpretation in the Ni-Nb System

High-spin Ferromagnetic State Observed in the Fe–Nb Alloys Synthesized by Ion Beam Mixing

Formation and Magnetic Properties of Metastable Phases Observed in the Fe50(HfxTa1−x)50 Films by Ion Beam Mixing

Non-equilibrium Phases in the Fe–Rh System Studied by Ion Beam Mixing and Ab Initio Calculation

Amorphous Phase Formation, Spinodal Decomposition, and Fractal Growth of Nanocrystals in an Immiscible Hf–Nb System Studied by Ion Beam Mixing and Atomistic Modeling

Metastable Phases Formed by Ion Mixing in the Hf-Nb System with A Positive Heat of Formation

Study Of Alloy Phase Formation Using Ion-Beams

Structural phase transition in the Hf–Ni system studied by ab initio calculation and ion beam mixing

Metastable Alloy Formation in the Immiscible Cu–Ru System by Ion Beam Manipulation

Metastable Phases Induced by Ion Irradiation in the Equilibrium Immiscible Fe–Cu System

Solid State Phase Transition Induced by Ion Irradiation in the Co-Nb System: Experiments and Thermodynamics

Some New Structural Transformations Induced By Ion-Beams

Nonequilibrium hcp and fcc phases formed by ion mixing in an immiscible Ni–Ru system