Abstract:Friction pendulum systems (FPS) and sliding bearings are widely used in bridges and buildings for seismic isolation. As their engineering applications increase, there is a growing need to understand the overall tribological performance of sliding-type bearings under severe earthquake conditions. Solid lubricants are the thin layers of polymer installed between the bearing sliding interfaces, and predominate the tribological performance of bearings. Despite advances in material science, few studies have investigated the tribological performance of bearings under seismic action. This study aimed to address this issue by conducting 48 tests with different pressure (15-50 MPa) and peak velocity (4-200 mm/s) levels using three commercially available solid lubricant formulas derived from polytetrafluoroethylene (PTFE). All lubricants exhibited a decrease in the friction coefficient as the pressure level increased. The friction coefficient increased with the peak velocity before 100 mm/s, and remained approximately constant thereafter. The surface wearing mechanism of filler-modified lubricants was different to that of unfilled PTFE. The wearing profile of lubricants was mostly pressure-insensitive and velocity-sensitive. The experimental results demonstrate the significant effect of the pressure and peak velocity on the friction coefficients and wear of bearing lubricants, and provide valuable insights for the design of future solid lubricants in FPS and other sliding bearings for aseismic applications.

Development of a Testing Worktable for Testing the Tribology Performance and Working Capability of Porous Bearing

Development of a Dynamical Load Testing Worktable for Porous Bearing

Worktable testing and testing accuracy analysis of tribology performance on porous bearings

Tribological Properties of Seals in Integrated Transmission of Vehicle

Development of the High-speed Sliding-rolling Contact Friction Testing Machine

Experimental Investigation of Tribological Behavior for FZ1460 Fe-Cu Porous Bearings

Development of Tribo-tester for Tribological Studies of Piston Ring/Bore Pair

Tribological and Vibration Properties of Three Different Polymer Materials for Water-Lubricated Bearings

Novel Tribometer for Coated Self-Lubricating Spherical Plain Bearings in a Vacuum

A Two-Disk Test Rig for Researching the Damage Behavior of Rolling/Sliding Contact Surfaces under Extreme Conditions

Experimental Investigation of Tribological Performance of Ptfe-Derived Solid Lubricants in Sliding Building Bearings

Study on the Tribological Properties and Fault Mechanisms of Copper-Based Alloy Journal Bearing under Different Working Conditions

Investigation on lubrication characteristics and deformation control of hydrostatic bearing workbench

Experimental and Modelling Study of Friction Evolution and Lubricant Breakdown Behaviour under Varying Contact Conditions in Warm Aluminium Forming Processes

Research on Improving the Tribological Properties of Bearings under Cryogenic Conditions

Design and Analysis of a Self-Lubricating Nuclear Joint Bearing above 320°C

Design and its realization of tribological - Dynamic design database

Experimental Study of Tribological Performance on Silicon Micro-textured Surface

A Mechanism Design of Friction and Wear Test Based on Liquid Medium

Investigation of tribological condition in cold forging using an optimized design of spike forging test

Tribological characteristics of solid-lubricant embedded Tin-bronze bearings