Abstract:Quench protection of full-size high-field accelerator magnets poses significant challenges. Maintaining the hot-spot temperature and peak voltage-to-ground within acceptable limits requires a protection system that quickly transitions most of the coil turns to the normal state. Existing magnet protection technologies, such as quench protection heaters or the Coupling Loss Induced Quench system (CLIQ), have been successfully applied. However, they both present shortcomings since they require either thin insulation between the heaters and the magnet conductor or direct electrical connections to the magnet coil. A novel quench protection method, Energy Shift with Coupling (ESC), is presented which can achieve excellent quench protection performance without the above-mentioned drawbacks. ESC relies on normal-conducting auxiliary coils strongly magnetically coupled with the magnet coils to protect. Upon quench detection capacitive units connected across such coils introduce a high current change in the auxiliary coils causing a rapid shift of magnet stored energy from the magnet coils to the auxiliary coils. This has three beneficial effects: sudden reduction of ohmic loss in the normal zone of the magnet conductor, introduction of high transient losses in the magnet conductor, thus causing a quick transition to the normal state, and extraction of a part of the magnet stored energy to the auxiliary coils. The applicability of the ESC concept on an existing magnet design is analyzed with electromagnetic and thermal transient simulations performed with the STEAM-LEDET program. The advantages and disadvantages of ESC are discussed and compared to other conventional quench protection methods. Simulation results show that ESC can be applied to protect full-scale magnets with reasonable requirements in terms of size and location of the auxiliary coils and of capacitive unit parameters.

NEW RESONANCE EARTH SYSTEM WITH MAGNETIC BIAS AND ITS PROTECTION

Study on simulation of ferroresonance elimination in 10kV power system

Directional Fault Detection Based on Active Power Coefficient in Resonant-Earthed Distribution System

MAGNETIC RESTRAINING DIFFERENTIAL BUS PROTECT

Analysis And Improvement On Stator Earth-Fault Protection By Injecting 20hz Signal

Synchronous Measurement Based Transient High Resistance Earth Fault Location in Resonant Grounding System

Impact of zero-sequence mutual inductance in UHV Anhui-to-east power transfer lines on phase-earth distance protection

Study on the differential protection of busbar with magnetic restraint

A Novel Selective Earth Fault Detection Method Using Residual Current

Analysis and Improvement on Stator Earth-Fault Protection by Injecting 20 Hz Signal

A Coupled FEM-BEM Methodology to Calculate 3D Earth Surface Potentials Caused by HVDC Return Currents

New Type Adaptive Distance Relay with Improved Performance

Restriction on Secondary Arc Current on Ultra-high Voltage AC Double Circuit Transmission Lines on the Same Tower

A New Protection Scheme for High Impedance Fault Using Adaptive Trip and Reclosure Technique

A Study of the Digital Grounding Fault Protection Scheme for Excitation Winding of Generator

Study on Single-Phase Grounding Current Protection of Distribution Line in Neutral Grounding System Via Arc Suppression Coil

Reliability-Enhanced Hybrid Grounding System Based on Active Neutral-Point Voltage Regulator and Low-Resistance

Fault Handling and Localization Strategy Based on Waveform Characteristics Recognition with Coordination of Peterson Coil and Resistance Grounding Method

Experimental Research on Typical Single-Phase High Resistance Grounding Fault Detection Methods in Resonant Grounding Distribution System

High resistance grounding fault feeder detection in a resonant grounding system based on transient current correlation coefficient comparison

Energy Shift with Coupling (ESC): a new quench protection method