Abstract:Quartz is a widely used material in the field of microelectromechanical systems (MEMS) for fabricating devices such as substrates, probes, and lenses; it is also indispensable as a resonator or oscillator for frequency control in communication and network technologies. However, its development is limited because it is difficult to fabricate an ideal profile for implementation in complex structures. In practice, wet etching is the most effective and extensive method for achieving the expected structure, although dry etching and other special machining techniques have also been investigated. In this study, the dynamic wet etching process was recorded using different ratios of buffered oxide etcher (BOE) solutions as the etchant to reveal the etching mechanism. The experiments were first designed considering the fabrication of samples, experimental conditions, and measurement indicators. Subsequently, the corresponding etch rate, roughness, and surface morphology were investigated to control the process parameters during wet etching. Different etchants exhibit varying etching rates and roughness properties. A smaller proportion of hydrofluoric acid in the BOE solution results in lower etch rate, and vice versa. The roughness (Ra) in the stable stage was not completely consistent with the tendency of the etch rate, whereas the surface morphology and dimensions of the pyramids rationally complied with the roughness trend. Additionally, the results suggested that the three following stages exist during the wet etching process of the z-cut α-quartz wafer; smooth, incremental, and stable. The analysis of the dynamic wet etching process in this study is beneficial for the structural design, manufacturing, and performance of quartz MEMS devices.

Ion Beam Etching of Quartz and BK7 Glass

Research on K9 Glass Wet Etching for MOEMS Devices

Etching Quartz with Inductively Coupled Plasma Etching Equipment

Characteristics of Several Common Optical Materials in Ion Beam Etching

Anisotropic Ion Beam Etching Of Fused Silica To Mitigate Subsurface Damage

Atomic Depth Image Transfer of Large-Area Optical Quartz Materials Based on Pulsed Ion Beam

A 16 Cm Broad-Beam Ion Source For Ion-Beam Etching Of Quartz Wafers

Investigation of physical properties of quartz after focused ion beam bombardment

Dynamic Process of Wet Etching Using BOE Solutions to Control the Etch Rate, Roughness, and Surface Morphology of a Z-cut Α-Quartz Wafer

Effect of Different Etching Processes on Surface Defects of Quartz Crystals

Deep Reactive Ion Etching of Z-Cut Alpha Quartz for MEMS Resonant Devices Fabrication

Recovery of fused silica surface damage resistance by ion beam etching

Influence of Ion-beam Etching Incidence Angle on Slope of Pattern Sidewall

Effect of ion beam etching on surface/subsurface structural defect evolution in fused silica optics

Ion beam etching of large aperture diffractive optical elements

Wet Etching of Quartz Using a Solution Based on Organic Solvents and Anhydrous Hydrofluoric Acid

Effect of Ion Etching on Polymethyl Methacrylate Surface

Ion Incidence Angle-Dependent Pattern Formation on AZ® 4562 Photoresist by Reactive Ion Beam Etching

Bessel Beam Femtosecond Laser Interaction with Fused Silica Before and After Chemical Etching: Comparison of Single Pulse, MHz-Burst, and GHz-Burst

Infrared Pulsed Picosecond Laser-Induced Plasma-Assisted Ablation of Micro-textures on Quartz Surface

An ion beam processing technology for complex component glass