Abstract:The thermal conductivity is an important parameter in the design of chemical engineering processes.In this study,a new transient hot wire apparatus for measuring thermal conductivity of liquid was established.The apparatus consists of a thermal conductivity cell with a platinum heating wire,a thermal bath,a circuit system and a data acquisition system.After calibrating the effective length of the platinum wire,the deviations between the experimental data and literature data were found to be within 1%.In order to provide essential data for the process design of the methyl ethyl ketoxime production and the development of its downstream products,the thermal conductivity of methyl ethyl ketoxime-methyl ethyl ketone system and methyl ethyl ketoxime-n-hexane system were measured by the established apparatus in the temperature range of 288～328 K at atmospheric pressure.The experimental data of heat conductivities were correlated as the function of composition and temperature,and the absolute average deviation between the experimental data and the calculated results of the correlated function are 0.13% and 0.36%,respectively.

Measurement of the Thermal Conductivity of Liquid Dimethoxymethane from 240 to 362 K

Thermal conductivity of liquid dimethyl ether from (233 to 373) K at pressures up to 30 MPa

Thermal Conductivity of Liquid 1, 2-Dimethoxyethane from 243K to 353K at Pressures up to 30MPa

Thermal Conductivity of Liquid Dimethoxymethane and Dimethoxymethane + Diesel Fuel at Pressures to 30 MPa

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Molecular Dynamics Simulation of Liquid Methanol

Density and Viscosity of Saturated Liquid Dimethoxymethane from (218.15 to 383.15) K

Thermal Conductivity of Dimethyl Carbonate in Liquid Phase

Thermal Conductivity of Gaseous Dimethyl Ether from (263 to 383) K

Thermal Conductivity Measurement from 30 to 750 K: the 3ω Method

Measurement of Thermal Conductivity for Systems of Methyl Ethyl Ketoxime with Methyl Ethyl Ketone and N-Hexane Separately

Thermal Conductivity of Liquid Diethylene Glycol Monomethyl Ether

Density and Viscosity Measurements of Dimethoxymethane and 1,2-Dimethoxyethane from 243 K to 373 K up to 20 MPa

Measurements of the Thermal Conductivity of 1,3-Dichloro-2-propanol + N , N -Dimethylformamide in the Temperature Range from 303 to 368 K at Pressures up to 15.10 MPa

Thermal conductivity measurements of the H<sub>2</sub>/CO<sub>2</sub> mixture using the short-hot-wire method at 323.15-620.05 K and 2.14-9.37 MPa

An Improved Hot Probe for Measuring Thermal Conductivity of Liquids

Measurement of thermal conductivities of [mmim]DMP/CH3OH and [mmim]DMP/H2O by freestanding sensor-based 3ω technique

Investigation on thermal conductivity of decamethylcyclopentasiloxane (D5) and decamethyltetrasiloxane (MD2M) in the liquid phase

Measurement and modeling of liquid thermal conductivity of linear siloxanes: Octamethyltrisiloxane (MDM) and Hexamethyldisiloxane (MM)

Surface Tension of Dimethoxymethane and Methyl Tert-Butyl Ether

Thermal Conductivity of Some Oxygenated Fuels and Additives in the Saturated Liquid Phase