Abstract:The two-phase isochoric heat capacity ( VT ), liquid–gas phase transition ( , ), vapor-pressure ( , ), and thermal -pressure coefficient of methyl dodecanoate, a key biofuels component, have been measured along nine liquid isochores between (180.90 and 845.31) kg·m −3 and three near-critical liquid and vapor (180.90, 234.52, and 374.11) kg·m −3 isochores. The temperature range covers the liquid–vapor phase transition temperature for each measured isochore to near the thermal decomposition temperature, 450 K. The measurements were performed using a high-temperature and high-pressure, nearly constant-volume adiabatic calorimeter previously used for the measurements of the VT relationship of biofuel components in the two- and single-phase region. The combined expanded uncertainty of the density ( ρ ), temperature ( T ), and isochoric heat capacity ( ) measurements at the 95% confidence level with a coverage factor of k = 2 is estimated to be 0.15%, 15 mK, and 2%, respectively. The isochoric heat capacity discontinuity point was used as the criteria of the liquid–gas phase transition temperature, . For each experimental liquid isochore, most measurements were concentrated in the immediate vicinity of the liquid–gas phase transition temperature ( ) to precisely determine the phase boundary properties ( , , , and ) using an isochoric heat -capacity abrupt-behavior technique. For nine liquid isochores between (745.16 and 845.31) kg·m −3 the phase transition temperatures ( ) were experimentally determined. For two vapor (180.90 and 234.52) kg·m −3 and liquid near-critical (374.11) kg·m −3 isochores, for which the transition temperatures are very high (above the thermal decomposition temperature, 473 K), we failed to reach the phase-transition temperatures, , because for these isochores the thermal decomposition of methyl dodecanoate occurs before reaching the phase transition temperature (above 673 K). The measured two-phase ( ) isochoric heat capacities as a function of specific volume ( V ) along the various isotherms (below 473 K) were used to accurately estimate the values of the second temperature derivatives of chemical potential, , and vapour-pressure, , based on the Yang–Yang theoretical relation. The contributions of the vapour-pressure, , and the chemical potential, , to the heat capacities of the measured total two-phase were estimated as a function of temperature. In addition, measured and phase boundary ( , , ) property data were used to calculate key thermodynamic property data , , , , , , along the saturation curve. The measured vapor-pressure ( − -Abstract Truncated-

Thermal Conductivity of Some Oxygenated Fuels and Additives in the Saturated Liquid Phase

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Experiment Investigation on the Liquid Thermal Conductivity of Biodiesel + Diesel Fuel Blends

Measurements on vapor pressure and thermal conductivity for pseudo-binary systems of a hydrocarbon fuel with ethylene and diethylene glycol dimethyl ethers

Densities, viscosities and refractive indices of binary liquid mixtures of methyl tert-butyl ether or ethyl tert-butyl ether with a hydrocarbon fuel

Thermal Conductivity Calculation in Organic Liquids: Application to Poly-α-Olefin

Thermal Conductivity of 1,2-Ethanediol and 1,2-Propanediol Binary Aqueous Solutions at Temperature from 253 K to 373 K

Measurement of Thermal Conductivity for Systems of Methyl Ethyl Ketoxime with Methyl Ethyl Ketone and N-Hexane Separately

Comparative Research on Laminar Flame Propagation for Four C8 Fuels

Investigation on liquid thermal conductivity of ethylene glycol (EG)/water mixtures: A comparative experimental and molecular dynamics simulation study

Heat capacities and thermal conductivity of ternary mixtures of water+ethanol+1,2-ethanediol between 75 and 350 K

Thermal conductivity of liquid hydrocarbons

Measurement of the Thermal Conductivities of Toluene, Cyclohexane, and Diethyl Ether at Pressures up to 15.1 MPa and Their Binary Mixtures at Pressures 0.1 and 10.1 MPa from 291 to 351 K

Thermal-Conductivity of Alcohols with Acetonitrile and N,N-Dimethylformamide

Thermal conductivity calculations of binary liquid organic mixtures by molecular dynamics simulation and its interpretation of microscopic heat transfer mechanism

Measurement and prediction of thermal conductivities of alkane binary mixtures

MEASUREMENT AND CALCULATION ON THERMAL CONDUCTIVITY FOR BINARY SYSTEMS OF ALCOHOLS WITH 1,2-DICHLOROETHANE AND WITH CYCLOHEXANONE

Thermophysical properties of the biofuel components: A mini-guide to the critical properties, heat capacities, and thermal conductivities

Two-Phase Isochoric Heat Capacity, Phase Transition, and Theoretically Important Physical Parameters of Methyl Dodecanoate

Experimental and Modeling Investigations of Density and Viscosity for the Ternary ( N -Octane + Ethylcyclohexane + Ethylbenzene) Mixtures

Thermal conductivity measurements for n-hexane and n-heptane at elevated temperature and pressure