Abstract:The electrochemical nature of the contact firing reactions is studied by short‐circuiting the Ag fingers to the underlying Si emitter. The short‐circuit effect is gradually attenuated along the finger line away from the short‐spot owing to the ohmic drop of the electrode potential along the Si substrate. The contact quality is strongly correlated to the Ag crystallites formed on the emitter surface. The 6‐in full‐cell tests demonstrate that the segmentation of Ag fingers does not necessarily mitigate the short‐circuit effect. The "short‐circuit effect" in the fire‐through Ag metallization of crystalline Si (c‐Si) solar cells refers to the poor contact formation caused by an electrical short between the Ag gridline and underlying Si emitter during contact firing. This study employs two different Ag pastes containing PbO‐ and TeO2‐based glass frits to investigate the dependence of the short‐circuit effect on the length and pattern of the Ag finger lines. The results show that regardless of the employed glass frits, the short‐circuit effect is mitigated even near the short spot and gradually attenuated along the finger line away from the spot as the Ag finger line extends radially longer than the critical length (>35 mm). We demonstrate that this attenuation is independent of the finger line width and predominantly attributed to the ohmic drop of the electrode potential along the Si substrate. The results also show that, regardless of the glass frits, the contact quality is strongly correlated with the density of the Ag crystallites that are formed on the Si emitter surface. The 6‐in full‐cell tests indicate that the isolation of the short spots by segmenting the Ag finger lines does not necessarily result in the mitigation of the short‐circuit effect. We suggest that the reduction of Ag+ on the Si emitter surface should be the key process that must be controlled to achieve high‐quality contacts during contact firing, providing further insights into the electrochemical characteristics of contact firing reactions for the future development of Ag pastes.

THE MEASUREMENT OF SCREEN PRINTED FINGER CONTACT RESISTANCE ON CRYSTALLINE SILICON SOLAR CELL

INFLUENCE OF SILVER PASTE COMPOSITION ON OF SCREEN-PRINTED OHMIC CONTACTS SILICON SOLAR CELLS

Study on the Front Contact Mechanism of Screen-Printed Multi-Crystalline Silicon Solar Cells

Influence of contact characteristics of SnO2/P on fill factor of solar cell

Detailed investigation of TLM contact resistance measurements on crystalline silicon solar cells

An analytical investigation on characterizing the properties of glass composition for crystalline silicon solar cells based on the digital microsystem measurement technology

Contact resistance: Its measurement and relative importance to power loss in a solar cell

Insight into the Contact Mechanism of Ag/Al–Si Interface for the Front‐Side Metallization of TOPCon Silicon Solar Cells

A contactless method of emitter sheet resistance measurement for silicon wafers

Attenuation of short‐circuit effect along screen‐printed silver gridlines during the contact firing process of crystalline silicon solar cells

EFFECT OF GLASS FRIT WETTING PROPERTY ON THE PERFORMANCES OF SILICON SOLAR CELLS

Investigation of the mechanism of the Ag/SiNx firing-through process of screen-printed silicon solar cells

Effect of the interface glass on electrical performance of screen printed Ag thick-film contacts of Si solar cells

Effect of Surface Texture on Pinhole Formation in SiO x-Based Passivated Contacts for High-Performance Silicon Solar Cells

Interfacial Engineering of Cu 2 O Passivating Contact for Efficient Crystalline Silicon Solar Cells with an Al 2 O 3 Passivation Layer

Influence of Glass Phase in Silver Paste on Metallized Contact Resistance between Rear Silver and Aluminum Electrodes of Crystalline Silicon PERC Cells

Solar cell contact resistance—A review

A General Method to Accurately Measure the Thin-Film Sheet Resistance for Sensors

Differently shaped Ag crystallites and four current transport paths at sintered Ag/Si interface of crystalline silicon solar cells

Influence of Silicon Substrate Surface Finish on the Screen‐Printed Silver Metallization of Polysilicon‐Based Passivating Contacts

Electron‐Selective Strontium Oxide Contact for Crystalline Silicon Solar Cells with High Fill Factor