Abstract:Optimizing the performance of front silver paste is of great significance in improving the efficiency of the photoelectric conversion of crystalline silicon solar cells. As a conductive functional phase of silver paste, the structure and performance of silver powder have an important influence on the sintering process of silver paste and the conductivity of silver electrodes. Because of their two−dimensional structure, flake silver powders can effectively increase the contact area with other silver powders and silicon cells before sintering. Additionally, flake silver particles have higher surface energy and sintering activity than spherical silver particles of the same particle size. However, recent research has mainly focused on the influence of the particle size of silver powder. This paper fills the research gap regarding the morphology of silver powders and clarifies the influence of flake silver powders on the performance of silver paste. The influence of the ratio of spherical silver powder to flake silver powder in silver paste on the sheet resistance, adhesion, and specific contact resistivity of silver film after sintering at 800 °C was studied, and the optimal ratio was determined according to a cross−sectional contact picture of the silver film. The results showed that with the increase in the mass fraction of the flake silver powder, the sheet resistance of the sintered silver film gradually increased, the adhesion first increased and then decreased, and the specific contact resistance first decreased and then increased. When the flake silver powder content was 0%, the minimum sheet resistance of the silver film was 2.41 m Ω/£. When the flake silver powder content was 30%, the maximum adhesion of the silver film was 6.07 N. When the flake silver powder content was 50%, the minimum specific contact resistivity of the silver film was 0.25 Ω·cm2. In conclusion, when the flake silver powder content was 30%, the comprehensive performance of the silver film was the best.

Influence of Glass Phase in Silver Paste on Metallized Contact Resistance between Rear Silver and Aluminum Electrodes of Crystalline Silicon PERC Cells

Al-induced variation to Ag crystal orientation of Ag–Al pastes during metallization

Insight of Effect of Silver Powders on Silver‐silicon Contacts of Crystalline Silicon Solar Cells through Analysis of Glass Structural Decay

Ohimc Contact Formation Mechanism of Silver–Aluminum Paste Metallization on the p+ Emitter of n-Type Crystalline Silicon Solar Cells

INFLUENCE OF SILVER PASTE COMPOSITION ON OF SCREEN-PRINTED OHMIC CONTACTS SILICON SOLAR CELLS

Insight into the Contact Mechanism of Ag/Al–Si Interface for the Front‐Side Metallization of TOPCon Silicon Solar Cells

Pb-free Silver Pastes with SnO-B2O3 Glass Frits for Crystalline Silicon Solar Cells

Effect of composition of front-electrode-paste glass on electrical performance of multicrystalline silicon solar cells

Effect of the interface glass on electrical performance of screen printed Ag thick-film contacts of Si solar cells

Effect of Ag Powder and Glass Frit in Ag Paste on Front Contract of Silicon Solar Cells

The influence of Bi2O3 glass powder in silver paste on the fabrication of ohmic contacts and its potential effectiveness in solar cells and integrated circuits on p-type silicon substrates

EFFECT OF GLASS FRIT WETTING PROPERTY ON THE PERFORMANCES OF SILICON SOLAR CELLS

The effect of Te-based lead-free glass powder containing Ge and Ag+ on the contact formation and electrical performance of silicon solar cells

Initiatively embedding silver colloids in glass used in silver paste to improve metallization ohmic contact on silicon wafers

Pb-free front-contact silver pastes with SnOP2O5 glass frit for crystalline silicon solar cells

Investigation of the effect of forming gas annealing on front silver electrodes of c-Si solar cells

Differently shaped Ag crystallites and four current transport paths at sintered Ag/Si interface of crystalline silicon solar cells

Experimental Investigation of Effect of Flake Silver Powder Content on Sintering Structure and Properties of Front Silver Paste of Silicon Solar Cell

Effects of Silver Nanoparticles on the Firing Behavior of Silver Paste on Crystalline Silicon Solar Cells

Effect of Glass Phase on Solder Joint Reliability in Crystalline Silicon Photovoltaic Modules

Model for contact formation of novel TeO2 containing Pb-free silver paste on n+ and p+ doped crystalline silicon