Abstract:Nanoindentation-based fracture toughness measurements of ceramic materials like silicon carbide (SiC) with pyramidal indenters are of significant interest in materials research. A majority of currently used fracture toughness models have been developed for Vickers indenters and are limited to specific crack geometries. The validity of the indentation-cracking method for the fracture toughness measurement of single crystal SiC, the elastic-plastic anisotropy and orientation dependence around the c-axis when indented in the direction is examined using nanoindentation with different pyramidal indenters. The residual impressions are analyzed using scanning electron microscopy to measure the crack lengths and the validity of existing fracture toughness measurement methods and equations is analyzed. A combination of nanoindentation with different pyramidal indenters to produce a wide range of effective strains and finite element simulation is used to extract flow properties of single crystal SiC in the direction. It is observed that there is no orientation dependence around the c-axis when SiC-6H is indented in the direction with a Berkovich indenter, i.e., it is transversely isotropic. It is also found that for a Berkovich indenter, the Jang and Pharr model, which is based on the Lawn model for cone/halfpenny cracks, gives approximately constant values at low loads ( 1 N), the Laugier model gives constant fracture toughness values. Finite element analysis using equivalent cones is used along with measured hardness values to estimate the yield strength, the work hardening exponents and the stress–strain curve for single crystal SiC-6H in the direction.

Statistical properties of indentation toughness for silicon nitride ceramic

Variation in the indentation toughness of silicon nitride

Statistical properties of indentation toughness of ceramics

Indentation toughness of ceramics: a statistical analysis

Strength/Crack-Size Relationship for Knoop-Indented Bending Specimens and Its Application to Silicon Nitride Ceramics

R-curve Behavior of Indentation Cracks in Silicon Nitride Based Ceramic Composite

Fracture from Knoop Indentation-Induced Flaws in Sintered Silicon Carbide and Hot-Pressed Silicon Nitride

Micromechanical characterization of zirconia and silicon nitride ceramics using indentation and scratch methods

Fracture Toughness Evaluation and Plastic Behavior Law of a Single Crystal Silicon Carbide by Nanoindentation

Statistical variability in the indentation toughness of TiCN particle reinforced Al2O3 composite

Assessing fracture toughness in sintered Al2O3–ZrO2(3Y)–SiC ceramic composites through indentation technique

A comparison between Knoop and Vickers hardness of silicon nitride ceramics

Indentation deformation and microcracking in β-Si 3N 4-based nanoceramic

Quantitative In-Situ Study of Strength-Governed Interfacial Failure Between H-Bn and Polymer-Derived Ceramic

Crack propagation in silicon nitride ceramics under various temperatures and grain boundary toughness

Indentation toughness of ceramics: A modified approach

Characterization of R-curve Behavior in Si3N4-based Ceramics

On the Local Crack Resistance of Al2O3–TiC Composites Evaluated by Direct Indentation Method

Load dependence of the apparent hardness of silicon nitride in a wide range of loads

Weibull modulus of fracture strength of toughened ceramics subjected to small-scale contacts

Evaluation by Indentation of Fracture Toughness of Ceramic Materials