Abstract:Nanoindentation-based fracture toughness measurements of ceramic materials like silicon carbide (SiC) with pyramidal indenters are of significant interest in materials research. A majority of currently used fracture toughness models have been developed for Vickers indenters and are limited to specific crack geometries. The validity of the indentation-cracking method for the fracture toughness measurement of single crystal SiC, the elastic-plastic anisotropy and orientation dependence around the c-axis when indented in the direction is examined using nanoindentation with different pyramidal indenters. The residual impressions are analyzed using scanning electron microscopy to measure the crack lengths and the validity of existing fracture toughness measurement methods and equations is analyzed. A combination of nanoindentation with different pyramidal indenters to produce a wide range of effective strains and finite element simulation is used to extract flow properties of single crystal SiC in the direction. It is observed that there is no orientation dependence around the c-axis when SiC-6H is indented in the direction with a Berkovich indenter, i.e., it is transversely isotropic. It is also found that for a Berkovich indenter, the Jang and Pharr model, which is based on the Lawn model for cone/halfpenny cracks, gives approximately constant values at low loads ( 1 N), the Laugier model gives constant fracture toughness values. Finite element analysis using equivalent cones is used along with measured hardness values to estimate the yield strength, the work hardening exponents and the stress–strain curve for single crystal SiC-6H in the direction.

Statistical properties of indentation toughness of ceramics

Indentation toughness of ceramics: a statistical analysis

Statistical variability in the indentation toughness of TiCN particle reinforced Al2O3 composite

Statistical properties of indentation toughness for silicon nitride ceramic

On the Local Crack Resistance of Al2O3–TiC Composites Evaluated by Direct Indentation Method

Statistical Analysis of Fracture Toughness of Soda-Lime Glass Determined by Indentation

Assessing fracture toughness in sintered Al2O3–ZrO2(3Y)–SiC ceramic composites through indentation technique

Indentation toughness of ceramics: A modified approach

Micromechanical characterization of zirconia and silicon nitride ceramics using indentation and scratch methods

Effect of TiC Particle Size on the Toughness Characteristics of Al2O3–TiC Composites

Evaluation by Indentation of Fracture Toughness of Ceramic Materials

The Influence of TiC-particle-size on the Fracture Toughness of Al2O3–30 Wt.%tic Composites

Evaluations on Ceramic Fracture Toughness Measurement by Edge Chipping

Fracture Toughness of Advanced Structural Ceramics: Applying ASTM C1421

Effect of Load-Dependence of Hardness on Indentation Toughness Determination for Soda-Lime Glass

Prediction of Ceramic Fracture with Normal Distribution Pertinent to Grain Size

The influence of crack forms on indentation hardness test results for ceramic materials

Weibull modulus of fracture strength of toughened ceramics subjected to small-scale contacts

Quantitative In-Situ Study of Strength-Governed Interfacial Failure Between H-Bn and Polymer-Derived Ceramic

Fracture Toughness Evaluation and Plastic Behavior Law of a Single Crystal Silicon Carbide by Nanoindentation

Variation in the indentation toughness of silicon nitride