Abstract:The preparation, microstructure and mechanical properties of ZTA particles reinforced Fe matrix composites (ZTA(P)/Fe composites) were systematically investigated. The X-ray diffraction (XRD), scanning electron microscopy (SEM) and electron probe microanalysis (EPMA) were used to analyze the microstructure and phase constituents, the hardness (H), Young's modulus (E) and plasticity factor (delta(A)) were determined as well. The nickel-chromium double-layer coated ZTA(P) of core-shell structure was prepared by electroless plating and multi-arc ion plating technologies. The modified ZTA(P) is consisted of the alpha-Al2O3, t-ZrO2, alpha-Cr and gamma-Ni phases. In addition, the compressive strength of ceramic preforms is high due to a compact sintering neck formed among ZTA(P) during high temperature sintering. The preferred sintering process for ZTA ceramic preforms is determined as 1350 degrees C + 1 h, in this case the preforms show the remarkable porosity and highest compressive strength which are 27.8% and 35.0 MPa, respectively. The interfacial metallurgical chemical reactions occurred during infiltration casting process, which ensure the excellent metallurgical interfacial bonding of the ZTA(P)/Fe composites. The interface contains double transition layers, which refer to silicate and CrFe phases, respectively. The H, E and delta(A) of interfacial double transition layers were measured by the nano-indentation method, the values of which are situated between the ZTA(P) and iron matrix.

PROPERTIES OF TiC-Al2O3/Fe COMPOSITES PREPARED BY SHS/PHIP

Microstructures of TiC-Al2O3-Fe composites prepared by SHS/PHIP

Study on mechanical properties of C-f/TiC-TiB2 composites combustion-synthesized by SHS

In situ synthesis and mechanical properties of bulk Ti3SiC2/TiC composites by SHS/PHIP

DENSE TiC-Al2O3-Fe CERMET FABRICATED BY SHS

Dense TiC-Al2O3 composites fabricated by SHS

Strength improvement and fracture mechanism in Fe40Al/TiC composites with high content of TiC

Densification, Microstructure and Mechanical Performance of TiC/Fe Composites by Spark Plasma Sintering

Investigation on microstructure of TiC-Fe cermets prepared by SHS/PHIP

TiC-Fe cermets fabricated by SHS

Microstructure, Mechanical Properties, and Sintering Behavior of Ti3O-Fe2TiO4-TiC Composites

Friction behavior of Ti-30Fe composites strengthened by TiC particles

The effect of carbon source and molar ratio in Fe–Ti–C system on the microstructure and mechanical properties of in situ TiC/Fe composites

Mechanical Properties and Microstructure of Fe40al/Tic Composites with Low Content of Intermetallic

Microstructure and Mechanical Properties of Fe Matrix Composites Reinforced by Nickel–chromium Double-Layer Coated ZTAP Ceramics

In-situ TiC/Ti composites based on Ti 2 AlC–Ti system: Reaction process, microstructure, and mechanical properties

MECHANICAL PROPERTIES OF TiC-Ni PRODUCED BY SHS AT ROOM AND HIGH TEMPERATURES

Effect of Dispersed TiC Content on the Microstructure and Thermal Property of Shrouded-Plasma-Sprayed FeAl/TiC Composite Coatings

Effect of Copper Content on the Microstructures and Properties of TiB<sub>2</sub> Based Cermets by SHS

The fabrication and mechanical properties of Ti3SiC2/HAp ceramics composites

High strength and high fracture toughness ceramic−iron aluminide (Fe3Al) composites