Abstract:High-k materials as an alternative dielectric layer for SiC power devices have the potential to reduce interfacial state defects and improve MOS channel conduction capability. Besides, under identical conditions of gate oxide thickness and gate voltage, the high-k dielectric enables a greater charge accumulation in the channel region, resulting in a larger number of free electrons available for conduction. However, the lower energy band gap of high-k materials leads to significant leakage currents at the interface with SiC, which greatly affects device reliability. By inserting a layer of SiO2 between the high-k material and SiC, the interfacial barrier can be effectively widened and hence the leakage current will be reduced. In this study, the optimal thickness of the intercalated SiO2 was determined by investigating and analyzing the gate dielectric breakdown voltage and interfacial defects of a dielectric stack composed of atomic-layer-deposited Al2O3 layer and thermally nitride SiO2. Current–voltage and high-frequency capacitance–voltage measurements were performed on metal–oxide–semiconductor test structures with 35 nm thick Al2O3 stacked on 1 nm, 2 nm, 3 nm, 6 nm, or 9 nm thick nitride SiO2. Measurement results indicated that the current conducted through the oxides was affected by the thickness of the nitride oxide and the applied electric field. Finally, a saturation thickness of stacked SiO2 that contributed to dielectric breakdown and interfacial band offsets was identified. The findings in this paper provide a guideline for the SiC gate dielectric stack design with the breakdown strength and the interfacial state defects considered.

Charge to Breakdown of Thin Gate Oxides

Substrate and Process Dependence of Gate Oxide Reliability of 0.18μm Dual Gate CMOS Process

Substrate and process dependence of gate oxide reliability of dual gate CMOS process

Off-state Avalanche-Breakdown-induced On-Resistance Degradation in SGO–NLDMOS

Localized Breakdown in Dielectrics and Macroscopic Charge Transport Through the Whole Gate Stack: A Comparative Study

Electrical Characteristics of 3-6nm Ultra-Thin Gate Oxide

Impact of Electrical Stress on Defect Generation in Thin GeO<sub>2</sub>/Ge Gate Stacks Fabricated by Thermal Oxidation

Modeling of Charge-to-Breakdown with an Electron Trapping Model for Analysis of Thermal Gate Oxide Failure Mechanism in SiC Power MOSFETs

Investigation of ultra-thin SiO/sub 2/ gate oxide characteristics

A Thorough Study of Quasi-Breakdown Phenomenon of Thin Gate Oxide in Dual-Gate CMOSFET's

The interfaces of lanthanum oxide-based subnanometer EOT gate dielectrics.

Breakdown Protection Characteristics for F and N Implanted Ultra-Thin Gate Oxide

Correlation of trap generation to charge-to-breakdown (Q/sub bd/): a physical-damage model of dielectric breakdown

Oxide Breakdown Reliability of SiC MOSFET

Study on Ultra-Thin Gate Dielectrics: Surface Preparation and Reliability

High Quality Ultrathin Gate Dielectrics Prepared by In-Situ RTP

Simulation and analysis of high breakdown voltage AlGaN/GaN MOSHEMTs with TiO2/Al2O3 gate dielectric

Current Conduction And Stability Of Ceo2/La2o3 Stacked Gate Dielectric

Saturation Thickness of Stacked SiO2 in Atomic-Layer-deposited Al2O3 Gate on 4H-Sic

Degradation Effects of Gate Oxide and Sti Charge in Soi Ldmos

Breakdown Characteristics of N2O-Annealed H2-O2 Grown Thin Gate Oxide