Abstract:A solution characterized by lengthening its short upper furnace was put forward for improving the gas/particle flow deflection and asymmetric combustion within a 600 MWe supercritical down-fired boiler. Based on the present design dimensionless upper furnace height C-H2 = 0.864, upper furnace was lengthened in turn to C-H2 = 1.00, 1.125, and 1.263 so as to form four comparable settings. Accordingly, cold-modeling gas/particle flow experiments and numerical simulations on coal combustion were performed at these settings for confirming the solution and meanwhile recommending a reasonable C-H2 setup. Moreover, real-furnace measurements, used to confirm the numerical simulation validity, were carried out under normal full load. Results at the design setting (C-H2 = 0.864) show shat a severely deflected gas/particle flow field appears, with (i) the downward gas/particle flow penetrating much deeper in the front-half side than in the rear-half side and (ii) the upward flow fully deflecting towards the front-half side. Consequently, a bad asymmetric combustion pattern with gas temperatures being much higher in the rear-half side than in the front-half side (temperature gap reaching about 300-600 degrees C) develops, generating poor burnout and high NOx emissions. Additionally, the simulated results are consistent well with the acquired real-furnace data. In comparison with cold-modeling gas/particle flow experiments, the simulated downward gas/particle flow penetrates clearly shallower in a hot environment. Lengthening upper furnace apparently weakens both the experimental and simulated flow-field deflection and meanwhile improves the asymmetric gas velocity distribution in the upper furnace. As C-H2 increases to 1.125 and 1.263, both the experimental and simulated flow-field symmetries are acceptable, accompanied by symmetrical gas velocity distribution in the upper furnace, improved burnout rate, and lowered NOx emissions. A comprehensive consideration of symmetrical combustion, high burnout rate, relatively low NOx emissions, and controlled cost for lengthening upper furnace suggests that a reasonable C-H2 should be set at 1.125. (C) 2017 Elsevier Ltd. All rights reserved.

Reformation of Ash Hopper of a Large Boiler

Experimental Investigation of the Scaling-Off Location and the Slag Mass in Pulverized Coal-Fired Boiler with Water-Cooled Slag Removal

Integrated Gas and Solid Model to Determine the Flow Performance in the SCR Reactor

RESEARCH ON ASH- CLINKER DEPOSITION PERFORMANCE IN WATER - COOLED BOT TOM ASH HOP PER WHILE BURNERS TILTING DOWN

Investigation On The Ash Deposition Of A Radiant Syngas Cooler Using Critical Velocity Model

Prediction of ash deposition in ash hopper when tilting burners are used

THE SIMULATION OF PARTICLE DEPOSITION IN ASH HOPPER WHEN NOZZLES TILTED DOWNWARDS

Mechanisms and strategies for ash deposition reduction in flue gas heat exchanger

RESEARCH AND ENGINEERING APPLICATION ON SOLVING SLAGGING PROBLEM OF HEXAGONAL TANGENTIALLY FIRED BOILER

Model Research On Material Balance In A Circulating Fluidized Bed Boiler

Investigation on the Ash Size Distribution and Attrition During the Coal Combustion in Fluidized Bed

Heat Transfer in the Rotary Ash Cooler with Residual Char Combustion Considered

Study on mixing performance of atmospheric entrained flow gasification burner using fine ash as feedstock

Model analysis of gas/solid flow behavior in standpipe of CFB combined with a pyrolysis reactor

Improving Gas/particle Flow Deflection and Asymmetric Combustion of a 600 MWe Supercritical Down-Fired Boiler by Increasing Its Upper Furnace Height

Experimental Study on Ash Deposition Characteristic of Convection Heating Surface in Waste Heat Boiler

Modeling of Multiphase Reaction and Slag Flow in Single-Burner Coal Water Slurry Gasifier

Alleviating Gas/Particle Flow Deflection and Asymmetric Combustion in A 600 Mwe Supercritical Down-Fired Boiler by Expanding Its Furnace Throat Space

Influence of Different Multi-Burner Arrangements on the Gas-Particle Flow Characteristics of an Improved Fine Ash Entrained-Flow Gasifier

Experimental Investigation On Three Coals Ash Formation

Understanding the Ash Deposition Formation in Zhundong Lignite Combustion Through Dynamic CFD Modelling Analysis