Abstract:Background The Shanghai synchrotron radiation facility (SSRF) is a third generation light source. It has been in operation for user experiment in decay mode since 2009. Meanwhile, the top-up operation is also under exploration in order to provide users with stable beam. A key technique for top-up mode is optimizing the injection efficiency by precisely controlling the injecting bunch charge. Therefore, it is essential to measure precisely the bunch charge at the high-energy transport line. The direct-current current transformers (DCCT) can measure the average beam current but can't measure the single bunch charge. Although the integrating current transformer (ICT) can measure the individual bunch charge, it is sensitive to different background noise with a resolution of less than 1% and even worse under low bunch charge case. [Purpose] This study aims to improve the measuring resolution for the injected individual bunch charge by using cavity charge monitor. [Methods] Since the cavity monitor has high sensitivity and high resolution, it will be used to extract the bunch charge information. Normally, the cavity monitor works at C-band frequency and the generated radio frequency signal (RF) has to be down-converted to intermediate frequency (IF) signal. Thus a dual-cavity monitor working at different frequencies was developed to realize the two RF signals self-mixing. Moreover, because of the limited signal sampling rate, the four channel signal splicing scheme with strict synchronous phase-locked sampling technique was addopted to further improve the sampling rate. [Results] The experimental results show that IF signal amplitude is linear to the bunch charge quantity. Moreover, the test results presents the measuring sensitivity is better than 0.03%. [Conclusion] The novel dual cavity bunch charge system works well and meets the requirement of injection bunch charge measurement.

Mechanism analysis and improvement measures of affecting DC current transformer (DCCT) under single bunch operation

Study on reliability improvement of current-transferring type HVDC circuit breaker

Study on precise bunch current measurement based on dual cavity monitor

High Precision Standard Testing System for Dcct

A Double-Break Current Injection Vacuum DCCB: Principle and Analysis

Adjusting the Number of In-use Cells for Higher Efficiency of A DC Solid State Transformer

DCCT System Design for SSRF Storage Ring

Interference Analysis and Protection of Electronic Current Transformer in DCB During No-load Closing of Transformer

Improvement of Bunch-by-bunch Beam Current Detection System in Hefei Light Source

Touschek lifetime study based on the precise bunch-by-bunch BCM system at SSRF

Optimization of DCCT System on Top-Up Operation Mode

Technical Assessment of Hybrid DCCB with Improved Current Commutation Drive Circuit

Study on the dynamic characteristic of the cryogenic current comparator

Research on the Methods of Measuring High Frequency Small Current in Large Power Frequency Current by Current Transformer

Studies of bunch lengthening at the BEPC

Improvement Study on the Measurement Method for the Dielectric Loss Factor of Transformer Bushing under Intermittent Heavy Load

Analysis of ECT effect on accuracy of measurement and protection

Double Air-gap Current Transformer Applied to High Voltage Transmission Line On-site Mobile Comparison System

Analysis and design of voltage doubling rectifier circuit for power supply of neutron source device towards BNCT

The Development and Performance of Dual-Core DC Tolerant Current Transformer

An Improved Design Method of High Efficiency Contactless Power Transmission in Ultrasonic Vibration System