Abstract:The high voltage bushing on the grid side of UHV converter transformer is located at the connection position between the grid side winding of converter transformer and the AC side system, which is the key equipment of UHVDC transmission system. In actual operation, the bushing will bear high temperature, large load current and additional load for a long time. In addition, due to the limitation of process level. During the rolling process of bushing capacitor core, there are inevitably some defects such as plate wrinkle, plate offset and unreliable grounding of the end plate. Under the long-term action of electricity, heat and stress, small defects are likely to develop into larger defects or even cause faults. Therefore, it is of great significance to study the influence of different defects on the electric field distribution in the bushing core and the partial discharge initial voltage (PDIV) of the bushing. On the basis of 550kV capacitive bushing, this paper designed and manufactured four scaled models. The rated working voltage of scaled models are 31.8kV. And the corresponding finite element simulation models are also established. The simulation results show that the wrinkle defect and offset defect will cause serious electric field distortion, resulting in a sharp increase of electric field at the defect. Ungrounded defects will completely change the distribution of electric field in the bushing, making the electric field concentrated in the insulating oil between the flange and the end plate. The measurement of PDIV shows that the wrinkle defect and offset defect can significantly reduce the PDIV which makes the bushing prone to PD at a lower voltage level and lead to fault. The initial voltage drop of ungrounded partial discharge is less, but the discharge amount is large. Therefore, the research of this paper has guiding significance for timely finding the original defects of bushing, preventing the development of defects, and solving the problem of frequent failure of converter bushing.

Improvement Study on the Measurement Method for the Dielectric Loss Factor of Transformer Bushing under Intermittent Heavy Load

Improvements and measurements of parameter identification for electric load

Calculation Method of Winding Eddy-Current Losses for High-Voltage Direct Current Converter Transformers

Evaluation of the Calculation Method for Stray Losses in Structural Parts of HVDC Converter Transformers

The influence of heavy load to the dielectric loss factor measure and the improvement

Notice of Retraction The influence of heavy load to the dielectric loss factor measure and the improvement

Study on Multi-parameter On-line Monitoring System for Transformer Bushing

An On-line Insulation Diagnosis Method for Transformer Bushing Based on Frequency Domain Spectroscopy under Transient Voltage Excitation

Evaluation Method of 500kV Transformer Bushing Insulation State Based on Active Power Loss

Intelligent Electronic Device of UHV Converter Transformer Bushing Monitoring

Investigation on distribution of electro-thermal coupled field and improved design of 1100 kV converter valve-side bushing

Dielectric Response Analysis of Oil-immersed Paper Insulated Bushing under Moisture

Influence Analysis on Defects in Bushing Core at Grid Side of Converter Transformer

Experimental Research On Cumulative Deformation Of Transformer Winding Induced By Short-Circuit Current Impacts

Study on the Electromagnetic Thermal Coupling Analysis Method for Valve Side Bushing of Converter Transformer under Multi-frequency Harmonic Current

Defect Analysis and Preventive Measures of Main Transformer Bushing Based on Frequency Domain Dielectric Spectroscopy

Life Monitoring and Evaluation Strategy of Traction Transformer on Freight Line

Surface Charge Accumulation Characteristics of Converter Transformer Valve-side Bushing and Influence on DC Transient Electric Field

The Inner Voltage Component Analysis and Testing System for Converter Transformer Valve Side Bushings

Study on Return Voltage Measurement of Oil-paper Insulation Testing Technology in Transformers

Quantitative Research on Accumulative Effect of Transformer Winding Deformation and Its Influence Degree Based on Time-Frequency Analysis of Vibration Signal