Abstract:The burgeoning demand for enhanced power-system safety means that there is increased attention on technologies for the detection and location of cable faults. The double-terminal fault location method, which senses a fault current using a current transformer (CT), is the most effective and widely applied method in industrial practice. However, CT sensors may suffer from magnetic saturation when exposed to a high fault current, resulting in significant location errors, and their sensitivity cannot be adjusted. To address this problem, this paper describes an improved method for the acquisition of fault signal and the identification of fault-wave arrival time in power cables. First, a novel noncontact sensor (NCS) is developed for the detection of electric fields, and its sensitivity-adjustment curves are obtained by theoretical calculation and simulation. Then, based on feedback variational mode decomposition (FVMD) and the Wigner–Ville distribution (WVD), an improved method (the FVMD + WVD method) for the identification of fault-wave arrival time is devised, and its efficacy and accuracy are verified by simulations in Power Systems Computer-Aided Design/Electromagnetic Transients including DC (PSCAD/EMTDC) software. Finally, the fault-wave arrival-time detection performance of the NCS is examined in a series of on-site DC and AC experiments based on damped AC technology. The results show that the NCS exhibits feasible and effective performance, and that its response can be appropriately tuned based on its sensitivity-adjustment curves. The FVMD + WVD method is more accurate than several other current methods, as its error is only 0.48%, and thus this method enables the practical location of cable faults. In sum, these findings demonstrate that the NCS and the FVMD + WVD method comprise an improved system for the detection and location of cable faults, which will enhance c-ble safety in power systems.

Double Air-gap Current Transformer Applied to High Voltage Transmission Line On-site Mobile Comparison System

Electromagnetic Disturbed Mechanism of Electronic Current Transformer Acquisition Card under High Frequency Electromagnetic Interference

Analysis of ECT effect on accuracy of measurement and protection

220 Kv Active Electronic Current Transformer

A Novel Current Transformer Based on Virtual Air Gap and Its Basic Measuring Characteristics

Multiphysics Structured Eddy Current and Thermography Defects Diagnostics System in Moving Mode.

Electronic Current Transformer with Non-magnetic Air Gap in Core

Temperature Characteristic Analysis on Electronic Current Transformer

The Development and Performance of Dual-Core DC Tolerant Current Transformer

Study on separable transformer's efficiency for contactless energy transmission system

Intelligent Contactless Current Measurement for Overhead Transmission Lines

On-line Demagnetization Method for an Iron Core CT

A high accuracy current comparator with electronic compensation

Infulence of Current Transformer Saturation on the Distance Protection

Introduction of an intriguing approach for eletric current transformer on-site examining repairing

A Double-Terminal Traveling-Wave-Based Method Using Novel Noncontact Sensors for Fault Location in Transmission Cable Lines

Design and Simulation of a New Model for Air‐gapped Current Transformers

The research and application on interfacing technology between Electronic Current Transformer and relay protection

Approach of Obtaining the Error of Current Transformers Through the Measurement of Turns Correction Factor and Impedance

High-Frequency and High-Current Transmission Techniques for Multiple Earth Electrical Characteristic Measurement Systems Based on Adaptive Impedance Matching through Phase Comparison

Fault tracing method for high voltage electronic current transformer during its performance test based on the FMEA