Abstract:Medium-voltage large-capacity dc transformer (DCT) is the key energy conversion link for building intelligent distribution grid. Increasing the voltage and capacity of single module in DCT can effectively improve the power density and reduce the system cost. Aiming at the integrated gate commutated thyristor (IGCT)-based high-capacity dc transformer (IGCT-HDCT), the asymmetric topology design and quasi-zero-loss switching composite modulation are proposed to achieve the construction of high efficiency and power density DCT. Through designing the snubber circuit and phase-shift ratio trajectory ingeniously, the zero-voltage switching-on and zero-current switching-off operation of the IGCT-HDCT can be maintained, which greatly reduces the switching loss and gives full play to the extremely low on-state loss characteristics of IGCT. Meanwhile, the full-range soft-switching operation (from no-load to full-load) can be achieved in the composite modulation without adding any auxiliary component. And the design of the snubber circuit is greatly simplified, which cannot only effectively limit the dv/dt and di/dt of power semiconductors, but also improves the power density and operating efficiency of IGCT-HDCT. Finally, the theoretical analysis of the proposed system solution is verified by building a 1.25 MW IGCT-HDCT engineering prototype, and the maximum operating efficiency reaches 98.6%-99.1%.

Adjusting the Number of In-use Cells for Higher Efficiency of A DC Solid State Transformer

Efficiency Enhancement of DC Solid-State Transformers by Dynamically Adjusting Active Cells

Fault Tolerance Scheme for a DC Solid State Transformer

A Soft-Switching Solid-State Transformer Module

A Soft-switching Universal-input Solid State Transformer

Design and experiment of a zero-voltage-switching module for bidirectional DC solid-state transformer

A Five-level AC/DC Converter for MV Solid-State Transformer

Research on Voltage and Power Balance Control for Cascaded Modular Solid-State Transformer

High Efficiency High Power Density Cellular 1mhz 380V-12V DCX for Future Data Centers

A DC Solid-State Transformer with DC Fault Ride-Through Capability

Light-Load Efficiency Improvement of MHz RDCX Based on Output Voltage Ripple and Resonant Pulse Number Control

High-Efficiency High-Density RDCX Modules Cascaded with CHB PFC Stage

A 1.8kw/in3 Power Density Cellular 380V-12V DCX with 98.4% Peak Efficiency Using Low NFoM Devices and Resonant Drive Transformer

A Hybrid Isolated Bidirectional DC/DC Solid-State Transformer for DC Distribution Network

Enhanced Fault-Tolerant Operation Strategy for Cascaded Vienna Front-End Based Solid-State Transformer

A Novel Hybrid DC Transformer Combining Modular Multilevel Converter Structure and Series-Connected Semiconductor Switches

Asymmetric Topology Design and Quasi-Zero-Loss Switching Composite Modulation for IGCT-Based High-Capacity DC Transformer

Back-to-Back H-Bridge Cell Based Modular Solid State Transformer with High-Frequency Link

A 98.4% Efficiency 380V-12V DCX with 1.3kw/in3 Power Density Using Low NFoM Devices and Resonant Drive Transformer

Modular High Efficiency High Density MHz DCX with Different Output Voltage Adaptation