Abstract:A new marine titanium alloy Ti80 was isothermally compressed on a Gleeble-3500 thermal simulator. The variation of flow stress under different processing parameters was studied and the elevated temperature constitutive equation and processing map were established. Based on the analysis of high power dissipation efficiency in safe region, the initial temperature of the bar stock was preliminarily determined as Ti80 alloy seamless tube was prepared through rotary piercing process. Finally, the estimation was verified by 3D thermo-mechanical coupled simulation as well as physical experiment. Results show that the sensitivity of flow stress of Ti80 alloy to the temperature varies under different strain rates. The flow stress increases sharply with the decreasing of temperature in alpha+beta phase field; while there is slight difference in single beta phase field. Taking strain compensation into consideration, the modified hyperbolic-sine Arrhenius type equation could give an accurate estimation of flow stress for hot deformation of Ti80 titanium alloy. The developed processing map shows two high power dissipation efficiency domains: one is in alpha+beta phase field with low strain rate, i.e. 925 similar to 975 degrees C/0.01 similar to 0.1 s(-1); the other is in the beta phase field with intermediate strain rate, i.e. 1050 similar to 1100 degrees C/0.1 similar to 1 s(-1). Finite element simulation for rotary piercing process was further conducted at initial temperature of 950, 1050 and 1100 degrees C for bar stocks. It is found that the plug force at temperature of 950 degrees C increases significantly to about 5 similar to 6 times higher than that in single beta phase field, and what is worse, piercing in alpha+beta phase field leads to rolled stock jamming in Diescher's mill. However, the piercing process in beta phase field can be conducted well. For reducing energy consumption, the temperature of 1050 degrees C is considered as the optimal choice. In the end, Ti80 alloy seamless tube was produced successfully in Diescher's mill.

Analysis of interface heat transfer coefficient of stainless steel during non-isothermal contact process

Temperature dependence of contact angles of water on a stainless steel surface at elevated temperatures and pressures: In situ characterization and thermodynamic analysis.

Temperature Dependence of the Dynamic Contact Angles of Water on a Smooth Stainless-Steel Surface under Elevated Pressures

Investigation on heat transfer coefficient of glass lubricated interface between P92 heat-resistant steel and H13 steel

An Experimental Study on Thermal Contact Conductance Across the SS316L/CuCrZr Interface

Development of Estimation Procedure of Contact Heat Transfer Coefficient at the Part–Tool Interface in Hot Stamping Process

Estimation of Interface Heat Transfer Coefficient of Ultra High Strength Steels in Hot Forming

Prediction of Piercing Temperature via Processing Map for a New Marine Titanium Alloy

Research on heat transfer coefficient in hot forging of TC18 titanium alloy

Influencing factors of thermal contact conductance between TC4/30CrMnSi interfaces

Influence of temperature and pressure on solid to solid thermal contact resistance

Investigation of the factors influencing the interfacial heat transfer coefficient in hot stamping

Theoretical and Experimental Study of the Rule for Heat Transfer Coefficient in Hot Stamping of High Strength Steels

Experimental Study on Heat Transfer Boundary Conditions for Steel Hot Extrusion Process

Numerical Analysis of the Effect of Processing Parameters on Temperature on the Contact Interface During High Strength Steel Cold Stamping

Influences of temperature and contact pressure on thermal contact resistance at interfaces at cryogenic temperatures

Effect of Oxide Scale on Temperature-Dependent Interfacial Heat Transfer in Hot Stamping Process

Effect of Heating Temperature on Microstructure and Properties of Ti/steel Clad Plates with Corrugated Interfaces

Influence of Heat Treatment on Microstructure and Mechanical Property of Austenitic Stainless Steel

Research on the Effect of Boundary Pressure on the Boundary Heat Transfer Coefficients Between Hot Stamping Die and Boron Steel

Investigation of Heat Transfer Performance of Double-Walled Pipes of Heat Exchanger for Power Plant Applications