Abstract:A new simulation method which can couple heat transfer happened in hot stamping is proposed.The interfacial heat transfer coefficient is inverse estimated by finite element method(FEM) and optimization method which make the temperature standard deviation between simulation and cylindrical experiment reach the minimum.Then the interfacial heat transfer coefficient(IHTC) is used in a hot stamping U-HAT model to obtain the heat flux data of all nodes on the tool work surface.Statistical analysis system(SAS) program is coded to process the heat flux data and calculate the time-averaged heat flux of each node.The time-averaged heat flux of all nodes corresponding with space coordinates are introduced as Neumann condition in quenching simulation performed by STAR-CCM+.The tool temperature,channel wall temperature and nonhomogeneous film heat transfer coefficient(FHTC) form steady-state quenching simulation are mapped into the hot stamping model by ABAQUS.At the moment,the IHTC and FHTC have been coupled into the steady-state hot stamping model which not only considers the heat transfer between hot blank and cold tool but also combines the heat transfer between tool and cooling water.A U-HAT tool adopted in the simulation is designed and manufactured to perform a continuous hot stamping experiment,and the steady temperatures of several specific points on the blank and tool are collected to compare with the results from simulation.The results indicate that comparing the temperature distribution of tool and blank before coupling,the value of temperature is nearly doubled after coupling and the temperature profile is migrated along inlet to outlet.Moreover,all relative errors of steady temperature at specific points between experiment and simulation are less than 10％.

Theoretical and Experimental Study of the Rule for Heat Transfer Coefficient in Hot Stamping of High Strength Steels

Theoretical and experimental research on heat transfer phenomena in hot stamping

Development of Estimation Procedure of Contact Heat Transfer Coefficient at the Part–Tool Interface in Hot Stamping Process

Experimental Characterization of Heat Transfer Coefficients During Hot Forming Die Quenching of Boron Steel

Investigations on the Interfacial Heat Transfer Coefficient During Hot Stamping of Ultra-High Strength Steel with Al-Si Coating

Numerical Simulation of Temperature Field, Microstructure Evolution and Mechanical Properties of Hss During Hot Stamping

Thermomechanical-Phase Transformation Simulation of High-Strength Steel in Hot Stamping

Investigation of the factors influencing the interfacial heat transfer coefficient in hot stamping

Thermal Contact Conductance Estimation and Experimental Validation in Hot Stamping Process

A Study on the Multi-Phase Transformation Kinetics of Ultra-High-strength Steel and Application in Thermal-Mechanical-phase Coupling Simulation of Hot Stamping Process

Characterization of the Interfacial Heat Transfer Coefficient for Hot Stamping Processes

Experimental Study on Thermodynamic Performance of Boron Steel B1500HS Used for Hot Stamping Process

Experimental Characterization of Heat Transfer Coefficients for Hot Stamping AA7075 Sheets with an Air Gap

Coupled of Thermal-Mechanical-transformation Numerical Simulation on Hot Stamping with Static Explicit Algorithm

Influence Factors of Non-uniform Phase Transformation in Hot Stamping Process of Ultra-High-Strength Steel Sheet

Thermo-mechanical coupled analysis and practical application of hot stamping of the ultra high strength steel BR1500HS

Hot Stamping Forming Processes and Experiments of 22mnb5 Ultra-high Strength Steels

Estimation of Interface Heat Transfer Coefficient of Ultra High Strength Steels in Hot Forming

Thermo-mechanical coupled simulation of hot stamping components for process design

Exponential Model of Strength-Hardness Mechanical Properties Analysis and Numerical Prediction in Hot Stamping

Coupling Heat Transfer Study of Hot Stamping