Abstract:In this study, a thermo-mechanical finite element model was developed to investigate the thermal deformation during a stamping process of an automotive body part. The stamping process was decomposed into the 6 sub-steps to reflect the physical boundary conditions found in an actual stamping equipment. The temperature distributions of the actual stamping process were measured by two thermography cameras. The developed numerical procedure was then validated against the measured temperature distributions. Due to the limited accessibility to the actual equipment and high reflectivity of the involved material, the reflectivity index for the thermal imaging device (i.e., emissivity) was experimentally determined. A sample specimen made of the same material with the die material was built. The thermocouples were placed underneath the specimen surface through holes and used to directly measure the surface temperature distribution. The emissivity for the sample specimen was then determined by comparing the temperature measured by the thermocouples to the temperature measured by the thermographic camera. When the lubrication oils were spread on the sample specimen, the emissivity was set to a value 0.7. The thermal images were corrected based on the emissivity experimentally obtained and used to validate the finite element model simulation for the stamping process. With the validated finite element model, the investigation on the variation in the temperature and stress during each sub-step was performed. With the zero thermal expansion rate, the pure thermal effect on the temperature distribution was simulated. The pure thermal deformation in the Blank (i.e., target surface) was similar to the spring back distance after the blank was released from the molds. During the stamping process, the heat generation was obtained due to either friction between surfaces and plastic deformation of the target surface. We found that the plastic deformation played a critical role in the final temperature rise.

Evaluation of Contact Heat Transfer Coefficient and Phase Transformation during Hot Stamping of a Hat-Type Part

Development of Estimation Procedure of Contact Heat Transfer Coefficient at the Part–Tool Interface in Hot Stamping Process

Thermo-mechanical coupled simulation of hot stamping components for process design

Characterisation of the Contact Pressure Dependent Interfacial Heat Transfer Coefficient for a Hot Stamping Process Following a Data Driven Approach

Theoretical and experimental research on heat transfer phenomena in hot stamping

Analysis of Phase Transformation Simulation and Prediction of Phase Distribution in High Strength Steel in Hot Stamping

Research on the Influence of Hot Stamping Process Parameters on Phase Field Evolution by Thermal-Mechanical Phase Coupling Finite Element

Characterization of the Interfacial Heat Transfer Coefficient for Hot Stamping Processes

Theoretical and Experimental Study of the Rule for Heat Transfer Coefficient in Hot Stamping of High Strength Steels

Coupled Numerical Simulation of Hot Stamping Process and Experimental Verification

Investigation of Cooling Effect of Hot-stamping Dies by Numerical Simulation

Experimental Characterization of Heat Transfer Coefficients During Hot Forming Die Quenching of Boron Steel

Investigation of the Hot-Stamping Process for Advanced High-Strength Steel Sheet by Numerical Simulation

Numerical modeling of the thermal deformation during stamping process of an automotive body part

Study on the Phase Transformation Simulation of Hot-Stamping

Thermo-Mechanical Coupling Analysis of the Actuating Mechanism in a High Speed Press

A New Wear Calculation Method for Galvanized Ultra-High-Strength Steel during Hot Stamping

Phase Transformation Simulation of High Strength Steel under Hot Stamping Process

Constitutive modeling of TA15 alloy sheet coupling phase transformation in non-isothermal hot stamping process

Estimation of Interface Heat Transfer Coefficient of Ultra High Strength Steels in Hot Forming

The coupled thermo-mechanical-microstructural finite element modeling of hot stamping process in 22MnB5 steel