Abstract:The present paper focuses on the heat transfer and contact pressure at the casting-die interface in squeeze casting process. Experiments were conducted and a "plate shape" was used to cast aluminum alloy A356 in H13 steel die. Based on the temperature measurements inside the die, the interfacial heat transfer coefficient (IHTC) at the metal-die interface was determined by applying an inverse approach. The pressure at the metal-die interface was measured by using Kistler pressure transducer. The acquired data were processed by a low pass filtering method based on Fast Fourier Transform (FFT). Besides, a set of methods was set up to verify the computer program for the inverse model. The results show that the pressure at the casting-die interface and the IHTC rose to the peak value almost simultaneously as soon as the pressure was applied by the press. The higher the applied pressure, the higher the peak value of the IHTC and the pressure at the casting-die interface. It was a pressure maintaining stage immediately after the pressure was applied. During this stage, the pressure at the casting-die interface decreased immediately after it reached the peak value. The IHTC sharply dropped at the beginning. Then, the decrease rate of the IHTC became lower and lower. Besides, the IHTC of the cases with pressure applied was much higher than those without pressure applied. It indicates that the applied pressure greatly improved the contact status of casting and die surfaces and reduced the thermal resistance between the two surfaces. The IHTC profiles of the cases with the pressures 23 MPa and 46 MPa applied did not make much difference, however, when the applied pressure reached 70 MPa, the influence of the pressure at the casting die interface on the IHTC became very remarkable. (C) 2017 Elsevier Ltd. All rights reserved.

An Experimental Study of Heat Transfer During Forced Air Convection

Influencing Factors of Heat Transfer Coefficient in Air and Gas Quenching

Heat transfer coefficient study for air quenching by expenriment and CFD modeling

Robust methodology for determination of heat transfer coefficient distribution in convection

Study on the Optimization of Heat Transfer Coefficient of a Rare Earth Wrought Magnesium Alloy in Residual Stress Analysis

Experimental and modeling study of the interfacial and convective heat transfer coefficients of 6061 aluminum alloy in hot gas forming

Laboratory Experimental Setup And Research On Heat Transfer Characteristics During Secondary Cooling In Continuous Casting

Experimental Characterization of Heat Transfer Coefficients During Hot Forming Die Quenching of Boron Steel

A FEM-Based Inverse Calculation Method for Determination of Heat Transfer Coefficient in Liquid Quenching Process

Study on the heat transfer coefficients during the heat treatment process of a turbine disk

An Experimental Study of Boiling Heat Transfer and Quench Front Propagation Velocity During Quenching of a Cylinder Rod in Subcooled Water

Cfd -Based Modelling On Inter Facial Heat Transfer For Water Quenching

Simulation Research on Temperature Filed and Thermal Stress Field of 7050 Aluminum Alloy Part in Quenching Process

Experimental study of heat-transfer coefficient of Al-Zn-Mg-Cu ultra-thick hot plate during multi-stage quenching

Experimental Characterization of Heat Transfer Coefficients for Hot Stamping AA7075 Sheets with an Air Gap

Optimizing the Aging Heat Treatment of Cast Aluminum Alloys

A Study of Interfacial Heat Transfer and Its Effect on Quenching when Hot Stamping AA7075

Experimental Study on the Heat Transfer Behavior and Contact Pressure at the Casting-Mold Interface in Squeeze Casting of Aluminum Alloy

Coupled Thermal-stress Numerical Simulation on Quenching of ZL205A Aluminum Alloy Thick-plate

Theoretical and Experimental Study of the Rule for Heat Transfer Coefficient in Hot Stamping of High Strength Steels

Experimental study of interfacial heat transfer coefficient for 7XXX series aluminum alloy in HFQ warm forming