Abstract:The interfacial heat transfer coefficient (IHTC) between the steel blank and die directly affects temperature distribution during hot forming of advanced high-strength steel automobile parts and further affects martensite microstructure distribution and formability. In this paper, an experimental platform is established and Beck's nonlinear inverse estimation method is employed to solve the IHTC and investigate the rules of IHTC following contact pressure. This paper demonstrates that the IHTC increases with the increase in contact pressure. An actual hot-formed automotive B-pillar was obtained in the experiment. Results show that a high contact pressure corresponds to a high IHTC, which promotes fast blank cooling on the fillet corner area. By contrast, a low contact pressure results in low IHTC and cooling rate on the side wall area. Thus, a significant temperature difference induces asynchronous martensite transformation between the fillet corners and the side walls, where crack is more likely to occur. As a solution, local oil coating is used on fillet corners with high contact pressure before hot forming to improve the formability and avoid cracks. This finding indicates that local oil coating can effectively weaken the heat transfer performance, balance the temperature field in the different areas of the part, and consequently achieve better formability for the hot forming process. (C) 2016 Elsevier Ltd. All rights reserved.

Effect of Oxide Scale on Temperature-Dependent Interfacial Heat Transfer in Hot Stamping Process

Characterization of the Interfacial Heat Transfer Coefficient for Hot Stamping Processes

Investigation of the factors influencing the interfacial heat transfer coefficient in hot stamping

Development of Estimation Procedure of Contact Heat Transfer Coefficient at the Part–Tool Interface in Hot Stamping Process

Investigations on the Interfacial Heat Transfer Coefficient During Hot Stamping of Ultra-High Strength Steel with Al-Si Coating

Investigation of the Interfacial Heat Transfer Coefficient of Sheet Aluminum Alloy 5083 in Warm Stamping Process

A Study of Interfacial Heat Transfer and Its Effect on Quenching when Hot Stamping AA7075

Characterisation of the Contact Pressure Dependent Interfacial Heat Transfer Coefficient for a Hot Stamping Process Following a Data Driven Approach

Study on the effect of die coating thickness on the interfacial heat transfer coefficient in squeeze casting of aluminum alloy

Effect of Tool Coating on Interfacial Heat Transfer Coefficient in Hot Stamping of AA7075 Aluminium Alloys

Research on the Effect of Boundary Pressure on the Boundary Heat Transfer Coefficients Between Hot Stamping Die and Boron Steel

Influence of Thermal Properties on K IHTC in Hot Forming

An Efficient Closed-Form Method for Determining Interfacial Heat Transfer Coefficient in Metal Forming

Effect of Contact Pressure on IHTC and the Formability of Hot-Formed 22mnb5 Automotive Parts

Understanding of the influence of process parameters on the heat transfer behavior at the metal/die interface in high pressure die casting process

Comparison of the methods for calculating the interfacial heat transfer coefficient in hot stamping

Numerical Analysis of the Effect of Processing Parameters on Temperature on the Contact Interface During High Strength Steel Cold Stamping

Thermo-mechanical coupled simulation of hot stamping components for process design

Influence Factors of Non-uniform Phase Transformation in Hot Stamping Process of Ultra-High-Strength Steel Sheet

A Study on Heat Transfer at Metal/Die Interface During High Pressure Die Casting of AM60B Alloy

Influence of Processing Parameters on Interfacial Heat Transfer Coefficient at the Metal-Die Interface of Die Cast Am50 Alloy