Abstract:The present paper focuses on the heat transfer and contact pressure at the casting-die interface in squeeze casting process. Experiments were conducted and a "plate shape" was used to cast aluminum alloy A356 in H13 steel die. Based on the temperature measurements inside the die, the interfacial heat transfer coefficient (IHTC) at the metal-die interface was determined by applying an inverse approach. The pressure at the metal-die interface was measured by using Kistler pressure transducer. The acquired data were processed by a low pass filtering method based on Fast Fourier Transform (FFT). Besides, a set of methods was set up to verify the computer program for the inverse model. The results show that the pressure at the casting-die interface and the IHTC rose to the peak value almost simultaneously as soon as the pressure was applied by the press. The higher the applied pressure, the higher the peak value of the IHTC and the pressure at the casting-die interface. It was a pressure maintaining stage immediately after the pressure was applied. During this stage, the pressure at the casting-die interface decreased immediately after it reached the peak value. The IHTC sharply dropped at the beginning. Then, the decrease rate of the IHTC became lower and lower. Besides, the IHTC of the cases with pressure applied was much higher than those without pressure applied. It indicates that the applied pressure greatly improved the contact status of casting and die surfaces and reduced the thermal resistance between the two surfaces. The IHTC profiles of the cases with the pressures 23 MPa and 46 MPa applied did not make much difference, however, when the applied pressure reached 70 MPa, the influence of the pressure at the casting die interface on the IHTC became very remarkable. (C) 2017 Elsevier Ltd. All rights reserved.

Investigation of the factors influencing the interfacial heat transfer coefficient in hot stamping

Development of Estimation Procedure of Contact Heat Transfer Coefficient at the Part–Tool Interface in Hot Stamping Process

Experimental and modeling study of the interfacial and convective heat transfer coefficients of 6061 aluminum alloy in hot gas forming

A Study on Heat Transfer at Metal/Die Interface During High Pressure Die Casting of AM60B Alloy

Experimental Characterization of Heat Transfer Coefficients During Hot Forming Die Quenching of Boron Steel

Study on the effect of die coating thickness on the interfacial heat transfer coefficient in squeeze casting of aluminum alloy

Understanding of the influence of process parameters on the heat transfer behavior at the metal/die interface in high pressure die casting process

Evaluation of Contact Heat Transfer Coefficient and Phase Transformation during Hot Stamping of a Hat-Type Part

Measurement of Temperature Inside Die and Estimation of Interfacial Heat Transfer Coefficient in Squeeze Casting

Investigation and Application of Inverse Determination of Interfacial Heat Transfer Coefficient in Vacuum Investment Casting

Determination of the Heat Transfer Coefficient at Metal–die Interface of High Pressure Die Casting Process of AM50 Alloy

Effect of Process Parameters, Casting Thickness, and Alloys on the Interfacial Heat-Transfer Coefficient in the High-Pressure Die-Casting Process

Study on Heat Transfer Behavior at Metal/Die Interface in Aluminum Alloy Die Casting Process - I. Experimental Study and Determination of the Interfacial Heat Transfer Coefficient

Experimental Study on the Heat Transfer Behavior and Contact Pressure at the Casting-Mold Interface in Squeeze Casting of Aluminum Alloy

STUDY OF INTERFACIAL HEAT TRANSFER COEFFI-CIENT BETWEEN METAL AND DIE DURING HIGH PRESSURE DIE CASTING PROCESS OF ALUMINUM ALLOY ADCl2Z

Thermo-mechanical coupled simulation of hot stamping components for process design

Influence of Processing Parameters on Interfacial Heat Transfer Coefficient at the Metal-Die Interface of Die Cast Am50 Alloy

Effects of Alloy Materials and Process Parameters on the Heat Transfer Coefficient at Metal/Die Interface in High Pressure Die Casting

A study on the heat transfer coefficient for high pressure die casting process of ADC12Z alloy

Study on Heat Transfer Behavior at Metal/Die Interface in Aluminum Alloy Die Casting Process - Ii. Effect of Process Parameters on the Interfacial Heat Transfer

Influencing Factors of Heat Transfer Coefficient in Air and Gas Quenching