Abstract:Ion mixing of multiple metal layers was conducted at 77 K in five selected binary metal systems, i.e. the Ag-Cr, Co-Cu, Cu-Fe, Fe-Mo and Fe-Nd systems, which all have a nearly zero or positive heat of formation (Δ H For ). TEM examination showed a common microscopic feature of localized amorphization after high dose ion irradiation, i.e. the amorphous phase was frequently interspersed in a crystalline matrix. EDS analysis was therefore carried out to determine the actual compositions of the phases formed. It revealed that all local amorphous regions resided within rather narrow composition ranges. The narrow range found here for amorphization is probably the reason that amorphous alloy formation was difficult in these systems. After comparing these observations with those reported earlier for the some 30 systems so far studied, it is found that the behaviour of ion mixing induced amorphization, and hence the binary metal systems, can be classified into two categories. The first category contains the readily amorphous phase forming systems and usually features very limited terminal solid solubilities along with large negative heat of formation. Typical examples are the Au-Ti, Ni-Mo, Ni-Nb and Ru-Zr systems. In these systems amorphization can be achieved over a wide composition range once a minimum dose is reached. For systems in the second category, amorphization is only allowed in a rather narrow composition range, as in the systems studied here. This is also the case when a system has a large solid solubility, even though its Δ H For is rather negative, e.g. the Mo-Ru and Au-V systems. In such situations, the results of phase formation may be sensitive to the composition as well as to the ion irradiation dose. The possible mechanism responsible for the different behaviors of phase formation by ion mixing are also discussed.

Unusual Alloying Behavior Observed in the Immiscible AgMo and AgNb Systems under Ion Irradiation

Formation and structural anomaly of the metastable phases in an immiscible Ag - Mo system studied by ion beam mixing and molecular dynamics simulation

Role of Interface in Ion Mixing Induced Amorphization in the Ag–Mo System with Very Positive Heat of Formation

Nonequilibrium Alloy Formation In The Immiscible Cu-Mo System Studied By Thermodynamic Calculation And Ion Beam Mixing

Abnormal Alloying Behaviour Observed in an Immiscible Zr–Nb System

Metastable alloys synthesized by ion mixing in immiscible Ti–Nb and Ti–Ta systems

Irradiation-induced Alloying in Immiscible Mo–Cu System Through Multilayer Technique

Different Alloying Behaviors of Co-Mo Multilayered Films Upon Ion Irradiation and Thermal Annealing

Formation of Amorphous Alloys Through the Multilayer Method in an Immiscible Y - Nb System

Alloying In An Immiscible Cu-Nb System Upon Solid-State Reaction

Phase Evolution Upon Ion Mixing and Solid-State Reaction and Thermodynamic Interpretation in the Ni-Nb System

Irradiation-induced Alloying in an Immiscible TaTi System

Amorphous Alloys Synthesized by Interface-Assisted Ion Beam Mixing in the Ag–W System with the Largest Positive Heat of Formation

Metastable Phases Formed by Ion Mixing in the Hf-Nb System with A Positive Heat of Formation

Ion-mixing-induced Amorphization in an Immiscible Au - Mo System with a Small Size Difference

Non-equilibrium Alloy Phase Formation and Transformation Driven by Ion Beam Mixing in the Fe-Hf-Nb Multilayers

Different Behaviors Of Amorphization Induced By Ion Mixing

Non-equilibrium Alloy Formation in the Ag–Zr System by Ion Beam Mixing

Solid State Phase Transition Induced by Ion Irradiation in the Co-Nb System: Experiments and Thermodynamics

Sequential Disordering During Ion-Induced Amorphization in the Mo–Fe Multilayered Films

Unusual Alloying Behavior At The Equilibrium Immiscible Cu-Nb Interfaces