Abstract:Ion mixing of multiple metal layers was conducted at 77 K in five selected binary metal systems, i.e. the Ag-Cr, Co-Cu, Cu-Fe, Fe-Mo and Fe-Nd systems, which all have a nearly zero or positive heat of formation (Δ H For ). TEM examination showed a common microscopic feature of localized amorphization after high dose ion irradiation, i.e. the amorphous phase was frequently interspersed in a crystalline matrix. EDS analysis was therefore carried out to determine the actual compositions of the phases formed. It revealed that all local amorphous regions resided within rather narrow composition ranges. The narrow range found here for amorphization is probably the reason that amorphous alloy formation was difficult in these systems. After comparing these observations with those reported earlier for the some 30 systems so far studied, it is found that the behaviour of ion mixing induced amorphization, and hence the binary metal systems, can be classified into two categories. The first category contains the readily amorphous phase forming systems and usually features very limited terminal solid solubilities along with large negative heat of formation. Typical examples are the Au-Ti, Ni-Mo, Ni-Nb and Ru-Zr systems. In these systems amorphization can be achieved over a wide composition range once a minimum dose is reached. For systems in the second category, amorphization is only allowed in a rather narrow composition range, as in the systems studied here. This is also the case when a system has a large solid solubility, even though its Δ H For is rather negative, e.g. the Mo-Ru and Au-V systems. In such situations, the results of phase formation may be sensitive to the composition as well as to the ion irradiation dose. The possible mechanism responsible for the different behaviors of phase formation by ion mixing are also discussed.

Role of Interface in Ion Mixing Induced Amorphization in the Ag–Mo System with Very Positive Heat of Formation

Role Of Interface In Ion Mixing Or Thermal Annealing Induced Amorphization In Multilayers In Some Immiscible Systems

Unusual Alloying Behavior Observed in the Immiscible AgMo and AgNb Systems under Ion Irradiation

Formation and structural anomaly of the metastable phases in an immiscible Ag - Mo system studied by ion beam mixing and molecular dynamics simulation

Ion-mixing-induced Amorphization in an Immiscible Au - Mo System with a Small Size Difference

Metastable Phases Formed by Ion Mixing in the Hf-Nb System with A Positive Heat of Formation

Nonequilibrium Alloy Formation In The Immiscible Cu-Mo System Studied By Thermodynamic Calculation And Ion Beam Mixing

Chemical and interface effects on glass forming ability under ion mixing in ZrTa system of positive heat of formation

Different Behaviors Of Amorphization Induced By Ion Mixing

Sequential Disordering During Ion-Induced Amorphization in the Mo–Fe Multilayered Films

Interface Assisted Formation of a Metastable Hcp Phase by Ion Mixing in an Immiscible Ag-Ni System

A Dodecagonal Phase Formed in an Immiscible Co-Ag System by Ion Mixing of Multilayers

Metastable alloys synthesised by ion mixing and thermodynamic and kinetic modelling

Irradiation-Induced Amorphization and Free-Energy Calculation in Immiscible Fe-Cu Multilayers

Phase Evolution Upon Ion Mixing and Solid-State Reaction and Thermodynamic Interpretation in the Ni-Nb System

Amorphous Films Formed Through A Multilayer Technique in an Immiscible Y-Mo System and Their Elastic Properties

Different Alloying Behaviors of Co-Mo Multilayered Films Upon Ion Irradiation and Thermal Annealing

Amorphous Alloys Formed by Ion Mixing or Solid-State Reaction in Immiscible Y-Refractory Metal Systems and Their Elastic Properties

Role of Interface in Forming Non-Equilibrium Hcp Phase by Ion Mixing in an Immiscible Au-Co System

A comparative study of metastable alloy formation by ion mixing and thermal annealing of multilayers in the immiscible Y–Zr system

Microstructure Evolution in Zr-Mo Multilayers Induced by Ion Irradiation