Abstract:The amorphous/crystalline (A/C) dual-phase structure is a new design strategy to improve the comprehensive performance of Mg alloys. However, the regulation mechanism of the amorphous phase size of the dual-phase Mg alloys is still unclear. Here, the mechanism and size effect of solid-state amorphization of the dual-phase Mg alloys is investigated using molecular dynamics/Monte Carlo simulations. The results indicate that the degree of solid-state amorphization of the dual-phase Mg alloys depends on three factors: the original size of amorphous phase, the diffusion of rare earth element Y, and A/C interface (ACI). The degree of solid-state amorphization of the alloys exhibits a significant size effect on the original size of amorphous phase. Except for the two models with the smaller original size of the amorphous phase, the degree of solid-state amorphization of the alloys decreases significantly with the increase of the original size of amorphous phase. It is worth noting that after relaxation, as the original size of amorphous phase increases, the distribution of Y atoms in the amorphous phase undergoes a transition from uniform distribution to segregation, and the larger the original size of amorphous phase, the more obvious the segregation phenomenon becomes. The results indicate that the segregation of Y atoms in the amorphous phase suppresses the solid-state amorphization of the alloys. The results show that the segregation of Y atoms in the alloys requires a larger original size of the amorphous phase and the presence of ACI, both of which are essential.

Amorphous Alloys Formed by Ion Mixing or Solid-State Reaction in Immiscible Y-Refractory Metal Systems and Their Elastic Properties

Amorphous Films Formed Through A Multilayer Technique in an Immiscible Y-Mo System and Their Elastic Properties

Al-Yb Amorphous-Alloys Produced by Ion Mixing or Solid-State Reaction

A comparative study of metastable alloy formation by ion mixing and thermal annealing of multilayers in the immiscible Y–Zr system

Role Of Interface In Ion Mixing Or Thermal Annealing Induced Amorphization In Multilayers In Some Immiscible Systems

Formation of Amorphous Alloys Through the Multilayer Method in an Immiscible Y - Nb System

Metastable Alloys Formed in Some Yb-Based Systems upon Ion Irradiation

Formation Of Amorphous Alloys By Ion Mixing And Its Thermodynamic And Atomistic Modeling In The Binary Metal Systems

Metastable alloys synthesized by ion mixing in immiscible Ti–Nb and Ti–Ta systems

Metastable alloys synthesised by ion mixing and thermodynamic and kinetic modelling

Role of Interface in Ion Mixing Induced Amorphization in the Ag–Mo System with Very Positive Heat of Formation

Amorphous Alloys Synthesized by Interface-Assisted Ion Beam Mixing in the Ag–W System with the Largest Positive Heat of Formation

Formation of Amorphous Alloys by Ion Beam Mixing and Its Multiscale Theoretical Modeling in the Equilibrium Immiscible Sc-W System.

Phase Transition of Al-Yb Alloy Films Upon Ion Irradiation and Thermal Annealing

Elemental partitioning-mediated crystalline-to-amorphous phase transformation under quasi-static deformation

Structural evolution during mechanical milling and subsequent annealing of Cu–Ni–Al–Co–Cr–Fe–Ti alloys

Unusual Alloying Behavior Observed in the Immiscible AgMo and AgNb Systems under Ion Irradiation

Atomic insights into the solid-state amorphization mechanism of amorphous/crystalline dual-phase Mg alloys

Influence of niobium and yttrium on plastic deformation energy and plasticity of Ti-based amorphous alloys

Microalloying and the mechanical properties of amorphous solids

Interface-Driven Solid-State Alloying in an Immiscible Cu-W System