Abstract:This paper describes the main results from an experimental investigation into the thermal stability of a cold-rolled Al–Y alloy. Tensile tests performed on specimens of the alloy and pure Al in annealed states reveal superior anti-softening properties of the former specimens relative to the latter counterparts. Origins of such thermal stability and underlying recovery and recrystallization kinetics are studied using electron microscopy and high energy X-ray diffraction (HEXRD) techniques. Microscopic observations reveal that recovery and recrystallization begin in the specimens of pure Al at a much lower temperature than in the specimens of Al–Y alloy. Onset of the recovery process in the Al–Y alloy is observed to begin with dislocation rearrangements in the β-Al3Y phases. The onset is followed by more substantial reduction in dislocation density, shrinkage of the β-Al3Y phases, and coarsening of the α-Al grains. The alloy contains stacking faults, which interestingly remain stable during the annealing treatments contributing to the thermal stability. The observed mechanisms are further confirmed by tracking the evolution of peaks under the in-situ synchrotron X-ray diffraction with heating. Onset of recovery was observed at 280 °C in both α-Al and β-Al3Y phases, while substantial shrinkage and spheroidization of β-Al3Y phases and decrease in dislocation density were detected at 400 °C causing loss of the alloy strength. Thermodynamic calculation showed that solubility of Y rapidly increases in α-Al at temperatures above 400 °C explaining the spheroidization and shrinkage of the β-Al3Y phases by diffusion of Y into the Al matrix.

Al-Yb Amorphous-Alloys Produced by Ion Mixing or Solid-State Reaction

Phase Transition of Al-Yb Alloy Films Upon Ion Irradiation and Thermal Annealing

Metastable Alloys Formed in Some Yb-Based Systems upon Ion Irradiation

Amorphous Alloys Formed by Ion Mixing or Solid-State Reaction in Immiscible Y-Refractory Metal Systems and Their Elastic Properties

Formation of Amorphous Alloys Through the Multilayer Method in an Immiscible Y - Nb System

The Alloying Effects of Ge and Si on Thermal Stability and Crystallization Behavior of Al-Y Binary Amorphous Alloys

A comparative study of metastable alloy formation by ion mixing and thermal annealing of multilayers in the immiscible Y–Zr system

Thermal Stability and Crystallization Behavior of Al86Ni9Y5 Amorphous Alloys with Different Si Addition

Crystallization of Amorphous Zr60Al15Ni25 Alloy

Synthesis of Amorphous Alloys and Amorphous–crystalline Composites in Ternary Ni–Nb–Zr System by Ion Beam Mixing

Crystallization Behavior of Zr55al10ni5cu30 Amorphous Alloys with Different Morphologies and Thermal History Conditions

Amorphous Alloys Synthesized by Interface-Assisted Ion Beam Mixing in the Ag–W System with the Largest Positive Heat of Formation

Atomic and electronic structure of amorphous Al–Zr alloy films

Phase Evolution Upon Ion Mixing and Solid-State Reaction and Thermodynamic Interpretation in the Ni-Nb System

Evaporated CuAl Amorphous Alloys and Their Phase Transition

Abnormal Alloying Behaviour Observed in an Immiscible Zr–Nb System

Outstanding Thermal Stability of Cold-Rolled Al–Y Alloy Revealed Using In-Situ Synchrotron X-ray Diffraction and Ex-Situ Microscopy

Amorphous-forming Ability and Crystallization Behavior of Mg_(80)Cu_(15)Y_5 Alloy

Structure, Properties and Response to Heat-Treatment of Melt-Spun Al-Y and Al-La Alloys

Amorphous Films Formed Through A Multilayer Technique in an Immiscible Y-Mo System and Their Elastic Properties

Crystallization of high stable Zr55Al10Ni5Cu30 bulk amorphous alloy