Abstract:The paper presents a novel non-contact microelectromechanical systems (MEMS) voltage sensor based on the piezoresistive effect of single-crystal silicon. The novelty of the proposed sensor design lies in the implementation of unique single-crystal silicon piezoresistive beams for voltage measurement. The sensitive structure of the sensor produces electrostatic force deformation due to the measured voltage, resulting in the resistance change of single-crystal silicon piezoresistive beams which support a vibrating diaphragm. The voltage can be measured by sensing the resistance change. Moreover, the sensor does not need an additional driving signal and has lower power consumption. The prototype of the sensor was fabricated using an SOI micromachining process. The piezoresistive characteristics of the sensor and the corresponding output response relationship were analyzed through theoretical analysis and finite element simulation. The voltage response characteristics of the sensor were achieved at power frequencies from 50 Hz to 1000 Hz in the paper. The experimental results showed that they were in good agreement with simulations results with the theoretical model and obtained good response characteristics. The sensor has demonstrated that the minimum detectable voltages were 1 V for AC voltages at frequencies from 50 Hz to 300 Hz and 0.5 V for AC voltages at frequencies from 400 Hz to 1000 Hz, respectively. Moreover, the linearities of the sensor were 3.4% and 0.93% in the voltage measurement range of 900–1200 V at the power frequency of 50 Hz and in the voltage measurement range of 400–1200 V at the frequency of 200 Hz, respectively.

Design and Experimental Study on Low-Noise Piezoelectric Charge Sensitive Amplifier (CSA)

Simulation and Design of Piezoelectric Microcantilever Chemical Sensors

A low-noise charge sensitive amplifier for MEMS capacitive sensors

Design and Test of Piezoelectric Cantilever Structure for Microvibration Pickup Sensor

Design and Fabrication of a Low-Noise CMOS Charge Sensitive Amplifier

Design of a charge-sensitive amplifier for MEMS piezoelectric hydrophone

A low noise charge sensitive amplifier with adjustable leakage compensation in 0.18µm CMOS process

Noise-analyzing of piezoresistive silicon materials

A Study of U-shaped Micromachined Cantilever Array

An aerosol deposition based MEMS piezoelectric accelerometer for low noise measurement

A Novel Low Output Offset Voltage Charge Amplifier for Piezoelectric Sensors

Design and Optimization of Laminated Piezoresistive Microcantilever Sensors

Noise Analyzing Of Piezoresistive Silicon Materials

Design and performance of a low-noise, low-power consumption CMOS charge amplifier for capacitive detectors

Design and Development of a Low-Power Wireless MEMS Lead-Free Piezoelectric Accelerometer System

Optimization of Sensitivity and Noise in Piezoresistive Cantilevers

A Low-Noise Charge-Sensitive Amplifier for Gainless Charge Readout in High-Pressure Gas TPC

Design and Testing of a Non-Contact MEMS Voltage Sensor Based on Single-Crystal Silicon Piezoresistive Effect

A Design of Miniaturized High Performance Charge Amplifier

On the Design of Piezoelectric MEMS Microspeaker for the Sound Pressure Level Enhancement

Fabrication and Analysis of Micromachined Cantilever Array