Abstract:During the operation of a steam turbine, its structural elements are subjected to significant thermal and mechanical loads. The consequence of the long-term effect of such a load is the accumulation of scattered fatigue damage to the material of the structural elements of the steam turbine, which is localized over time in the form of fatigue cracks of various types. Evidence of this is several accidents and catastrophic failures of steam turbines due to significant fatigue damage to the shafting. The localization of damage in turbine rotors is facilitated by stress concentration in the gouges and fillets, as well as damage to the surface layer of the rotors during the thermomechanical treatment stage since all metal processing operations (forging, turning and milling, heat treatment) are accompanied by plastic deformation of the material. One of the reasons for the long-term accumulation of fatigue damage in the structural elements of steam turbines is thermal stresses, which can reach dangerous values during turbine startup operations. In certain parts of the rotors, these stresses are sufficient to cause scattered fatigue damage to the material (the so-called thermoplasticity), especially when starting the turbine from a cold state. In the case of crack initiation, the thermal stresses are all the more sufficient for its further intensive development even when starting the turbine from uncooled and hot states, which are less damaging than starting from the cold state. To study the intensity of crack growth in the turbine rotor due to thermal stresses arising during turbine startup, a computational model based on using a finite element model of the shaft of the K-200-130 steam turbine and fracture mechanics approaches is proposed. Studies based on the proposed computational model have demonstrated the ability to predict the process of crack growth in the rotor due to turbine startup from different thermal states and assess its danger to structural integrity. The initial size of the internal annular crack was determined, which has the potential for further intensive growth under the influence of thermal stresses.

Transient Characteristics Analysis of Thermal-Stress in Start-Stop Condition for Rotor System in Gas Turbine

Optimization of Start-up Process in Combined Cycle Steam Turbine of a Power Plant

Study on Quick Start-up of Steam Turbine in a Gas-Steam Combined Cycle

Analysis of Wind Turbine Vibration Characteristics during Startup and Shutdown Process

Optimization on Start-up Process of Steam Turbine in Combined Cycle Generating Units

Transient Thermal Stress Analysis of Power Turbine Welded Rotor in a Heavy-Duty Gas Turbine During Rapid Load Changes

Calculation of Finite Element of Thermal Stress and Analysis of Low-cyclic Fatigue Life for Non-central Hole Rotor of 135 MW Turbine

Flow-thermo-elastic coupled vibration characteristics of aeroengine high pressure rotor at the typical start and stop conditions

Damage Analysis and Start-Up Schedule Optimization of Steam Turbine Rotors With an Anisotropic Damage Coupled Viscoplastic Constitutive Model

Investigation on Dynamic Stresses of Pump-Turbine Runner during Start Up in Turbine Mode

Research on low temperature brittleness of 30Cr1Mo1V high-temperature rotor and its life optimization in rapid start-up and warm-up process

Analysis of the Rotor System of a Micro -Gas Turbine Engine Based on Finite Element Method

Rotor Stress and Dynamics Analysis of a High-Speed Permanent Magnet Machine for a Micro Gas Turbine Considering Multiphysics Factors

Modal Verification and Strength Analysis of Bladed Rotors of Turbine in Rated Working Conditions

Temperature rise rate of steam turbine at cold-state start-up considering the hardness changes of rotor materials

The Influence Made by the Central Hole of Steam Turbine Rotor to Temperature and Stress Distribution of Rotor

Patterns of Growth of an Internal Annular Crack Under the Influence of Thermal Stresses During Turbine Startup

New Monitoring Model of Thermal Stresses on Steam Turbine Rotors

Stress variation of a gas turbine tie-bolt rotor with Hirth serrations considering assembling and thermal effects

Research on Model-Based Fault Diagnosis for a Gas Turbine Based on Transient Performance

Influence of Different Loads on the Stresses of Multistage Axial Compressor Rotors