Abstract:Bulb turbine units are widely used in run-of river or dam projects with relatively low head, and can also be used for tidal energy utilization. Some types of bulb turbines have excessive vibration and fatigue failure problems, which threats their fatigue life. The model analyzed in this paper is a prototype bulb turbine rotor which suffered cracks, probably due to erosion and welding defects. The dynamic stress characteristics are analyzed under not only the non-cracked shaft condition but also the cracked one, to find possible causes of the failure. The computational fluid dynamics (CFD) simulation is performed to obtain reliable hydraulic load on the runner for performing the FEM analysis. The CFD results are verified by comparing with the site test for the prototype one. The linear elastic fracture mechanics theory combined with the fluid-structural interaction theory is applied to developing a cracked FEM model, to obtain the dynamic stress characteristics for the runner, shaft and rotor. The results reveal that the change in dynamic stress level on the shaft flange root significantly depends on the operating conditions, and the stress amplitude on the shaft mainly depends on the structural weight. The stress at the cracked zone could be up to 376.5 MPa in the best efficiency point, with only 1.5 years of fatigue life. Based on the numerical calculations and site inspection, it could be concluded that the insufficient sealing could lead to leakage flows with specific flow rates in flange root, which resulted in the occurrence of erosion; in addition, the welding at the flange root probably generated tiny defects. These two factors are likely lead to fatigue cracks and major failure of the shaft. Suggestions for solutions for the problems of the shaft are also discussed. Results of this study helps to find the reasons of the shaft fatigue failure. Furthermore, the analysis method could be used for an accurate calculation of fatigue life and providing guidance in future designs and operations of bulb turbine units.

Calculation of Finite Element of Thermal Stress and Analysis of Low-cyclic Fatigue Life for Non-central Hole Rotor of 135 MW Turbine

Fatigue Life Evaluation of Wind Turbine Tower Based on Measured Data

Analysing the Influence in Real-Time Calculation Fatigue Consume Caused by Model Layer of Turbing Rotor

Fatigue Crack Propagation Analysis in an Aero-Engine Turbine Disc Using Computational Methods and Spin Test

Study on Fatigue Degradation Behavior of a Cracked Rotor Subjected to Lateral Vibration

A Hybrid Modeling Method of Fatigue Crack Growth for Gas Turbine Blades under Combined High and Low Cycle Fatigue Loadings

Analysis of Fatigue Life of Turbine Generator Rotor

Analysis of thermal-mechanical coupling strength and fatigue life of cylinder head

A Combined High and Low Cycle Fatigue Model for Life Prediction of Turbine Blades

The Influence Made by the Central Hole of Steam Turbine Rotor to Temperature and Stress Distribution of Rotor

Multiaxial creep–fatigue failure mechanism and life prediction of a turbine blade based on a unified numerical solution approach

A modified nonlinear cumulative damage model for combined high and low cycle fatigue life prediction

Data-physics-model based fatigue reliability assessment methodology for high-temperature components and its application in steam turbine rotor

Multiaxial Strain Analysis in Large Wind Turbine Blades under Full-scale Fatigue Testing

Fatigue analysis in rotor of a prototype bulb turbine based on fluid-structure interaction

A New Energy-Critical Plane Damage Parameter for Multiaxial Fatigue Life Prediction of Turbine Blades

Substructure-based distributed collaborative probabilistic analysis method for low-cycle fatigue damage assessment of turbine blade-disk

Fatigue Failure Analysis of Shaft for NTK300 Wind Turbine

Reliability-based Low-Cycle Fatigue Damage Analysis for Turbine Blade with Thermo-Structural Interaction

Damage Analysis and Start-Up Schedule Optimization of Steam Turbine Rotors With an Anisotropic Damage Coupled Viscoplastic Constitutive Model

Fatigue life prediction for wind turbine main shaft bearings