Abstract:With the advancement of semiconductor manufacturing technology, thin film structures were widely used in MEMS devices. These films played critical roles in providing support, reinforcement, and insulation in MEMS devices. However, due to their microscopic dimensions, the sensitivity of their parameters and performance to thermal stress increased significantly. In this study, a Pirani gauge sample with a multilayer thin film structure was designed and fabricated. Based on this sample, finite element modeling analysis and thermal stress experiments were conducted. The finite element modeling analysis employed a combination of steady-state and transient methods to simulate the deformation and stress distribution of the device at room temperature (25 °C), low temperature (−55 °C), and high temperature (125 °C). The thermal stress test involved placing the sample in a temperature cycling chamber for temperature cycling tests. After the tests, the resonant frequency and surface deformation of the device were measured to quantitatively evaluate the impact of thermal stress on the deformation and resonant frequency parameters of the device. After the experiments, it was found that the clamped-end beams made of Pt were a stress concentration area. Additionally, the repetitive thermal load caused the cantilever beam to move cyclically in the Z direction. This movement altered the deformation of the film and the resonant frequency. The suspended film exhibited concavity, and the overall trend of the resonant frequency was downward. Over time, this could even lead to the fracture of the clamped-end beams. The variation of mechanical parameters derived from finite element simulations and experiments provided an important reference value for device design improvement and played a crucial role in enhancing the reliability of thin film devices.

Generalized Thermal Design Model for Comb-Capacitor Mems Devices Fabricated by Bonding-Drie Process: A Preliminary Framework

Micro-dielectric-droplet impingement cooling system based on MEMS

A Compact Model for Electro-Thermal Co-Simulation of One Diode-One Resistor Random Access Resistive Memory

Macro modeling method for electrostatic-drive silicon diaphragm

Thermal Analysis on Active Heat Dissipation Design with Embedded Flow Channels for Flexible Electronic Devices

Structural Optimization and Mechanical Simulation of MEMS Thin-Film Getter–Heater Unit

Recent Efforts in Modelling Combined Rate, Size and Thermal Effects on Single Crystal Strength

Capacity Evaluation of a MEMS Based Micro Cooling Device Using Liquid Metal As Coolant

Processes-based Multistep Simulation of Thermal- mechanical Reliability of a 3D-TSV MEMS

Study on the influence of doping process on resistance of semiconductor bridge region

Thermal properties analysis of MEMS sensors by micro-grid method

Coupled Finite Element-Finite Volume Multi-Physics Analysis of MEMS Electrothermal Actuators

Thermal-Mechanical-Electrical Coupled Design of Multilayer Energy Storage Ceramic Capacitors

Optimization and Fabrication of MEMS suspended structures for nanoscale thermoelectric devices

Design and fabrication of MEMS devices using the integration of MUMPs, trench-refilled molding, DRIE and bulk silicon etching processes

Temperature Gradient Method for Alleviating Bonding-Induced Warpage in a High-Precision Capacitive MEMS Accelerometer

Analytical Multistage Thermal Model for FEOL Reliability Considering Self-and Mutual-Heating

Test Structures and Drie Topography for Bulk Silicon Mems Devices

Numerical Study on Hybrid Discontinuous Microchannel Heat Sink Combining Manifold with Pin Fins (DMC-MPF) for High Power Electronic Device

A Heat Conduction Structure for the Etching Process of MEMS Devices with Support Anchors

Variation of MEMS Thin Film Device Parameters under the Influence of Thermal Stresses