Abstract:Electromechanical impedance (EMI) technology, as one of the important methods for analyzing and studying the interaction between sensors and structures, has the characteristics of clear physical meaning and high computational efficiency. However, for complex structures, it is difficult to quantitatively combine the measured impedance signal with the physical parameters of the tested structure. Therefore, establishing an appropriate EMI model is crucial to facilitate the quantitative analysis of structural health monitoring. The impedance models developed so far assume perfect adhesion between PZT and the structure, with displacement compatibility, and ignore the shear lag effect of the adhesive layer. Therefore, this research focuses on analyzing how surface-bonded PZT couples with the structure through the adhesives and conducting a shear layer analysis on two-dimensional (2-D) circular PZT to derive a closed-form solution for shear lag distribution. The shear lag effect is integrated into the 2-D impedance formula. The influence of the adhesive layer on bolt loosening monitoring is studied, and it is proven that the modified EMI model can effectively predict the shear lag effect of the adhesive layer. The result of relative error analysis proves that conventional adhesive PZT also exhibits the shear lag phenomenon. The influence of different thicknesses of adhesive layers on sensor sensitivity is studied. The experimental results show that as the thickness of the adhesive layer decreases, the monitoring sensitivity of the sensor increases. Moreover, for slight bolt loosening, the thickness of the adhesive layer can affect the monitoring frequency.

Influence of Package on Micro-Accelerometer Sensitivity

Thermal stress of MOEMS Accelerometers Based on Grating Interferometric cavity

Finite Element Simulation on Packaging of Hinged High-G Micromachined Accelerometer

Study on Package Thermal Stress of Multi-ranged Micro-accelerometer

Study on the packaging technology for a high-G MEMS accelerometer

Determination of Thermally Induced Effects and Design Guidelines of Optomechanical Accelerometers

Study of Multi-ranged Piezoresistive Micro Accelerometer Package Failure under High Overload

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Low stress packaging of a micromachined accelerometer

Accurate Assessment of Packaging Stress Effects on MEMS Sensors by Measurement and Sensor–Package Interaction Simulations

A Study on Packaging of PZT MEMS Microphone

Study and characterization of plastic encapsulated package for a three-axis piezoresistive acceleromete with guard-ring structure

Investigation and experiment of high shock packaging technology for High-G MEMS accelerometer

Modeling and Simulation of A Silicon Integration Tri-Axial Piezoresistive MEMS Accelerometer Chip Used for High Impact Test

Piezoresistive Slot-Cantilever Type Accelerometer Inspired from Spider'S Slit Sensilla

A SOI Sandwich Differential Capacitance Accelerometer with Low-Stress Package

Micro Accelerometer Reliability in Shock Environment

A Micro and Low-Cost Packaging Technology of High Accuracy Piezoresistive Pressure Sensors with Parylene Coating.

Packaging Effect on MEMS Pressure Sensor Performance

A Capacitive Micro-Accelerometer Based on LTCC Laminates

Research on the influence of an adhesive layer on the monitoring signal of piezoelectric sensors