Abstract:A strain-insensitive temperature sensor based on multimode interference using standard multimode fibers (MMFs) is proposed according to the comprehensive study of the characteristics of the MMFs. The temperature and strain dependences on the core diameter, numerical aperture (NA), and the length of the MMF section in the single-mode--multimode--single-mode (SMS) fiber structure are investigated experimentally. The results indicate that the larger core diameter of the MMF leads to higher temperature sensitivity but lower strain sensitivity (absolute values); the higher NA does not influence the temperature sensitivity but results in higher absolute value of strain sensitivity; the longer MMF section brings lower temperature sensitivity but does not have an impact on strain sensitivity. These findings also contribute to the theoretical analysis of the length dependence in the SMS fiber sensors. Besides, the results of the characterization study show that the strain sensitivity is relatively low, which brings a possibility to develop a strain-insensitive temperature sensor. The proposed sensor is used for temperature sensing while the strain is constantly applied from 0 to 1100 $\mu\epsilon$ with steps of 100 $\mu\epsilon$. The measured results are consistent with the comprehensive study. The mean temperature sensitivity is 6.14 pm/$^{\circ}$C with a standard deviation of 0.39 pm/$^{\circ}$C, which proves that the proposed temperature sensor exhibits good stability and is insensitive to strain. We expect that these results will provide a profound guideline to fiber sensors based on multimode interference.

Strain Sensor Based on Modal Interference of Polarization Maintaining Fiber

Strain Sensor Based on Gourd-Shaped Single-Mode-multimode-single-mode Hybrid Optical Fibre Structure.

A Compact Fiber Sensor Based on the High Birefringence Polarization Maintaining Fiber for Simultaneous Strain and Temperature Measurement

Temperature Insensitive Distributed Wide-dynamic-range Strain Sensing based on Polarization-Maintaining Photonic Crystal Fiber

The Strain Sensor with Enhanced Sensitivity Based on Improved Optical Fiber Michelson Interferometer

A strain sensor based on in-line Mach-Zehnder interferometer with thin-core fiber

Fiber-optic multimode interference sensing: comprehensive characterization and its potential for strain-insensitive temperature sensing

A Novel Strain Sensor with Large Measurement Range Based on All Fiber Mach-Zehnder Interferometer

Miniature Fiber-Optic Strain Sensor Based on a Hybrid Interferometric Structure

Highly sensitive strain sensing using a polarization-maintaining photonic crystal fibre based Mach–Zehnder interferometer

Interferometric Fiber Optic Surface Plasmon Resonance Sensor for Temperature and Strain Measurement

High Sensitivity Strain Sensor Based on a Novel Offset-Core Single Micro-Tapered Fiber-Optic Mach-Zehnder Interferometer

Temperature and Strain Sensor Based on a Few-Mode Photonic Crystal Fiber

High-Sensitivity Microfiber Strain and Force Sensors

Development of optical fiber strain sensor system based on machine learning and polarization

Sagnac interferometer-based optical fiber strain sensor with exceeding free spectral measurement range and high sensitivity

Quasi-distributed frequency-modulated continuous-wave reflectometric optical fiber strain sensor

An in-fiber Mach–Zehnder strain sensor for studying multimode interference of light

ALLOMETRIC EXPONENTS SUPPORT A 3/4-POWER SCALING LAW

High Precision Temperature Insensitive Strain Sensor Based on Fiber-Optic Delay

Strain-Insensitive Optical Fiber Sensor for Temperature and Salinity Measurement With Polynomial Surface Decoupling Algorithm