Abstract:Summary Material properties and geometrical shape of rolled products are two of the most important problems in steel product, which are affected by the thermal distribution and deformation behavior during rolling. Analysis of the behavior of medium plate during multi-pass rolling is significant for guiding the production. Recently years, the finite element method (FEM) has been widely used for analyzing the plate rolling processes, which has become an irreplaceable theory method. Rolling processes is a kind of continuous metal forming technology. Through multi-pass rolling processes, the shape and microstructure of plate could be obtained. However, in mostly works, the researchers focused on analysis of behavior of plates in a single pass, which the deformation of plate in previous passes are neglected. Itis obviousthatmore helpfulmassagescouldbeobtainedtoanalyze the behavior of plate deformation behavior in continuous multi-pass rolling processes. In this paper, a three-dimensional thermal-mechanical finite element model is established for simulation of the continuous deformation behavior of medium plate during multi-pass rolling processes coupled with explicit dynamic FEM, implicit FEM and updating geometrical method. Firstly, establishand solve thethermo-mechanical FE model of the i pass. Then obtain the thermal distribution on plate and obtain the plate shape after the i pass using the updating geometrical method. And establish and solve the thermal distribution of plate between the i pass and the i+1 pass. The thermal distribution in plate, the plate shape, etc, during rolling in the i pass are obtained. Modify the rolls gap and metrical parameters, the FE model of the i+1 pass could be established with the geometrical model and thermal distribution when i < N. With the same method, the following passes could be simulated. The plate view pattern, the thermal distribution, the maximum temperature on slab surface, the minimum temperature on slab surface and the mean temperature on slab surface each pass in the rolling processes were obtained. The calculated results are compared with the actual results, which are in good agreement. The model could be used in the hot working process.

Study on the Slab Design of Medium Plate Hot Rolling

Development and Application on Simulation System of Plate Rolling

Production Practice of Rolling 8mm Thickness Plate by 4300mm Heavy Plate Mill

The Causes and Control of Longitudinal Edge Cracks of the Plate

Optimization of Temperature Distribution in Thick Slab Continuous Casting for Direct Hot Rolling

Study on the Prediction of Rolling Force of 16mnr Hot Rolled Plate

The influence of process parameters on the mechanical properties of hot rolling dual phase heavy steel plate

Optimizing Rolling Strategies for API 5L X80 Steel Heavy Plates Produced by Thermomechanical Processing in a Reversible Single-Stand Mill

Research and application of the angular rolling technology for plate mill

Investigation on Shearing and Local Formability of Hot-Rolled High-Strength Plates

Development of Thin Slab Continuous Casting-Direct Rolling Process and Microalloyed High Strength Steel

Multi-pass Medium Plate Rolling Processes Using Thermo-mechanical FE Analysis

Numerical Study of the Thermodynamic Behavior and Wear on the Surface of Hot-Rolling Descaling Roll

Optimization of Hot Rolling Scheduling of Steel Strip with High Bending Performance

The Cracks on Slab Corner During Hot Rolling Process

In situ observation and investigation of effect of cooling rate on slab surface microstructure evolution in microalloyed steel

Analysis of Internal Cracks in Continuous Casting Slabs with Soft Reduction

Research on configuration and scheduling optimization for heating furnace process

STUDY ON ROLL WEAR ON HOT STRIP ROLLING MILL

Research on short process rolling of high performance wear resistant steel/carbon steel clad plate

Effect of Recrystallization on Roll Gap Setting of Medium Plate Rolling