Abstract:Summary Material properties and geometrical shape of rolled products are two of the most important problems in steel product, which are affected by the thermal distribution and deformation behavior during rolling. Analysis of the behavior of medium plate during multi-pass rolling is significant for guiding the production. Recently years, the finite element method (FEM) has been widely used for analyzing the plate rolling processes, which has become an irreplaceable theory method. Rolling processes is a kind of continuous metal forming technology. Through multi-pass rolling processes, the shape and microstructure of plate could be obtained. However, in mostly works, the researchers focused on analysis of behavior of plates in a single pass, which the deformation of plate in previous passes are neglected. Itis obviousthatmore helpfulmassagescouldbeobtainedtoanalyze the behavior of plate deformation behavior in continuous multi-pass rolling processes. In this paper, a three-dimensional thermal-mechanical finite element model is established for simulation of the continuous deformation behavior of medium plate during multi-pass rolling processes coupled with explicit dynamic FEM, implicit FEM and updating geometrical method. Firstly, establishand solve thethermo-mechanical FE model of the i pass. Then obtain the thermal distribution on plate and obtain the plate shape after the i pass using the updating geometrical method. And establish and solve the thermal distribution of plate between the i pass and the i+1 pass. The thermal distribution in plate, the plate shape, etc, during rolling in the i pass are obtained. Modify the rolls gap and metrical parameters, the FE model of the i+1 pass could be established with the geometrical model and thermal distribution when i < N. With the same method, the following passes could be simulated. The plate view pattern, the thermal distribution, the maximum temperature on slab surface, the minimum temperature on slab surface and the mean temperature on slab surface each pass in the rolling processes were obtained. The calculated results are compared with the actual results, which are in good agreement. The model could be used in the hot working process.

Effect of Recrystallization on Roll Gap Setting of Medium Plate Rolling

The Influence of Warm Rolling Reduction on Microstructure Evolution, Tensile Deformation Mechanism and Mechanical Properties of an Fe-30Mn-4Si-2Al TRIP/TWIP Steel

Recrystallization Behavior and Mechanical Properties of Az31b Alloy During the Hot-Rolling Process

The Causes and Control of Longitudinal Edge Cracks of the Plate

Static softening behavior of 316L stainless steel under flexible rolling process

Recrystallization and grain growth in hot rolling

The central strain analytical modeling and analysis for the plate rolling process

Analysis of rolling force and layer thickness in bimetal clad rolling

Calculation and analysis of rolling force during aluminum alloy thick plate snake/gradient temperature rolling with different roll diameters

Effect of Grain Size and Processing Parameters on Critical Strain for Austenite Dynamic Recrystallization

Study on dynamic recrystallization of ultra-high strength 22MnB5 steel during hot rolling

Influence of process conditions and pore morphology on the closure rate of pores in hot rolling of steel

Effect of Deformed Prior Austenite Characteristics on Reverse Phase Transformation and Deformation Behavior of High-Strength Medium-Mn Steel

Effect of rolling reduction below γ non-recrystallization temperature on pancaked γ, microstructure, texture and low-temperature toughness for hot rolled steel

Effect of Grain Size and Residual Strain on the Dynamic Transformation of Austenite under Plate Rolling Conditions

The theoretical model of the effective strain establishment for the plate during the snake rolling

Study on the Influence of Mandrel Speed on the Titanium Tube Continuous Retained-Mandrel Rolling Process

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

Construction of the Recrystallization Model of Low Carbon Steel During Deformation

Multi-pass Medium Plate Rolling Processes Using Thermo-mechanical FE Analysis

Finite element model simulation and back propagation neural network modeling of void closure for an extra-thick plate during gradient temperature rolling