Abstract:According to the equal flow shear stress at the interface in adjacent finite volumes, the traditional finite volume method (FVM) is improved in consideration of the viscosity variation in adjacent finite volumes. The new discretization and computing formulae concerning velocity gradient at the center of finite volume, as well as velocity and its gradient at the interface are deduced for the improved FVM. The new discretization and computing formulae are apt to the situation that melt viscosity varies very quickly during the filling stage of plastic injection molding. The improved FVM can avoid steep oscillation of flow shear stress in adjacent finite volume. Similarly, according to equal heat flux at the interface in adjacent finite volumes, the new discretization and computing formulae of temperature gradient are also deduced when the changing of heat conductivity coefficient in adjacent finite volumes is taken into account. Thus the improved FVM results in numerical stability and accuracy in the simulation of filling stage. The presented approach is used to simulate the steady laminar flow in a cylinder and the filling stage of a box, a plate with concave groove and a plastic part with general 3D features. The simulation results agreed well with the theoretic solution, experimental data and those from commercial software respectively. So the improved approach is verified to be able to exactly simulate the filling stage of plastic injection molding. In practice, it can also be theoretically applied in the coupled simulation of other single fluid or multi fluid.

Simulations of Three-Dimensional Thermal Residual Stress and Warpage in Injection Molding

3D Simulation of Residual Thermal Stress and Shrinkage in Plastic Injection Molding

Warpage of Injection-Molded Thermoplastics Parts: Numerical Simulation and Experimental Validation

Residual stresses, shrinkage, and warpage of complex injection molded products: Numerical simulation and experimental validation

Simulation and Experimental Analysis on Non-circular Cross-section Parts Residual Wall Thickness of Water-assisted Injection Molding

Effect on Residual Wall Thickness of Parts with Floating Core Injection of Water-Assisted Injection Molding

Local thermal warpage deformation of polypropylene injection molded flat part and neural network prediction model

Integrated Simulation of Fluid Flow and Heat Transfer in Injection Molding for the Prediction of Shrinkage and Warpage

INTEGRATED SIMULATION OF MELT FLOW, FIBER FRACTURE AND FIBER ORIENTATION FOR FIBER REINFORCED PLASTICS IN INJECTION MOLDING

3D Flow Simulation for Viscous Nonisothermal Incompressible Fluid in Injection Molding

Injection over-molding warpage prediction of continuous fiber-reinforced thermoplastic composites considering yarn reorientation

3D Simulation of Filling Stage of Plastic Injection Molding Based on Improved Finite Volume Method

Mold modification methods to fix warpage problems for plastic molding products

A dual‐scale three‐dimensional thermo‐viscoelastic model for the hot stamping simulation of thermoplastic composites

Optimization and prediction of volume shrinkage and warpage of injection-molded thin-walled parts based on neural network

Numerical Optimization of Shrinkage and Warpage on the Injection Molding Process Parameters of Electrical Connector

Model and Simulation of Water Penetration in Water-Assisted Injection Molding

Dispersed Phase Deformation Modeling of Immiscible Polymer Blends in Injection Molding

Warpage analysis and optimization of thin-walled injection molding parts based on numerical simulation and orthogonal experiment

Warpage control of thin shell parts of injection-molded using taguchi method

Numerical Simulation of Thermal Stress of Shaped Casting Based on Rheological Model