Abstract:This study focuses on applying intelligent modeling methods to different injection molding process parameters, to analyze the influence of temperature distribution and warpage on the actual development of auto locks. It explores the auto locks using computer-aided engineering (CAE) simulation performance analysis and the optimization of process parameters by combining multiple quality characteristics (warpage and average temperature). In this experimental design, combinations were explored for each single objective optimization process parameter, using the Taguchi robust design process, with the L18 (21 × 37) orthogonal table. The control factors were injection time, material temperature, mold temperature, injection pressure, packing pressure, packing time, cooling liquid, and cooling temperature. The warpage and temperature distribution were analysed as performance indices. Then, signal-to-noise ratios (S/N ratios) were calculated. Gray correlation analysis, with normalization of the S/N ratio, was used to obtain the gray correlation coefficient, which was substituted into the fuzzy theory to obtain the multiple performance characteristic index. The maximum multiple performance characteristic index was used to find multiple quality characteristic-optimized process parameters. The optimal injection molding process parameters with single objective are a warpage of 0.783 mm and an average temperature of 235.23 °C. The optimal parameters with multi-objective are a warpage of 0.753 mm and an average temperature of 238.71 °C. The optimal parameters were then used to explore the different cooling designs (original cooling, square cooling, and conformal cooling), considering the effect of the plastics temperature distribution and warpage. The results showed that, based on the design of the different cooling systems, conformal cooling obtained an optimal warpage of 0.661 mm and a temperature of 237.62 °C. Furthermore, the conformal cooling system is smaller than the original cooling system; it reduces the warpage by 12.2%, and the average temperature by 0.46%.

Warpage control of thin shell parts of injection-molded using taguchi method

Process Control of Injection Molding Based on Multiscale Visualization Methodology - A Case Study

Warpage analysis and optimization of thin-walled injection molding parts based on numerical simulation and orthogonal experiment

Design and Parametric Optimization of the Injection Molding Process Using Statistical Analysis and Numerical Simulation

Analysis of the Warpage Phenomenon of Micro-Sized Parts with Precision Injection Molding by Experiment, Numerical Simulation, and Grey Theory

Effect on Residual Wall Thickness of Parts with Floating Core Injection of Water-Assisted Injection Molding

Influence of mold design and injection parameters on warpage deformation of thin-walled plastic parts

Simulation and Experimental Analysis on Non-circular Cross-section Parts Residual Wall Thickness of Water-assisted Injection Molding

Application of Intelligent Modeling Method to Optimize the Multiple Quality Characteristics of the Injection Molding Process of Automobile Lock Parts

Recent progress in minimizing the warpage and shrinkage deformations by the optimization of process parameters in plastic injection molding: a review

Numerical Optimization of Shrinkage and Warpage on the Injection Molding Process Parameters of Electrical Connector

Influence of process parameters and post-molding condition on shrinkage and warpage of injection-molded plastic parts with complex geometry

Optimization of the injection molding process for the PC/ABS parts by integrating Taguchi approach and CAE simulation

Quality prediction and control of thin-walled shell injection molding based on GWO-PSO, ACO-BP, and NSGA-II

Warpage and Shrinkage Optimization of Injection-Molded Plastic Spoon Parts for Biodegradable Polymers Using Taguchi, ANOVA and Artificial Neural Network Methods

A method combining optimization algorithm and inverse-deformation design for improving the injection quality of box-shaped parts

Research on Lightweight Injection Molding (CAE) and Numerical Simulation Calculate of New Energy Vehicle

Part weight control via model free optimization for injection molding

Mold modification methods to fix warpage problems for plastic molding products

Research on Optimization of Injection Molding Process Parameters of Automobile Plastic Front-End Frame

Mold design and forming process parameters optimization for passenger vehicle front wing plate